Small AdvantEdge™ Punch System Starter Set

Small AdvantEdge™ Punch System Starter Set

Small AdvantEdge™ Punch System Starter Set
Questions?
Call Customer Service:
1-866-348-5661
101230-1001
Small Cartridge
Base
Inserting small cartridge:
1. Open “wings” on small
cartridge.
2. Snap the punch
cartridge, with the
paper slot in front, into
the small punch starter
set base.
3. To remove punch
cartridge, push
cartridge out through
hole in base.
How to use Small AdvantEdge™ Punch:
1. Center your paper and
slide it into the punch,
aligning it flush with
the back of the punch.
Press the lever to
punch.
2. Slide the paper left or
right until the newly
punched pattern lines
up with the printed
pattern on the base.
Press the lever to
punch again, and
repeat on both sides of
the center punch until
the border is complete.
Questions?
Call Customer Service:
1-866-348-5661
AdvantEdge™ Punch System Starter Set
100570-1001
Base
Large Punch Cartridge
Adapter Plate
Inserting large cartridge:
front
1. Insert cartridge into carriage, snapping into place
back to front.
2. To remove, pull up on
front of cartridge and
lift out.
back
paper slot
Inserting small cartridge with adapter:
1. Open “wings” on
small cartridge.
2. Snap into adapter,
paper slot facing
front.
3. Insert back of adapter
into carriage, push
front of adapter down.
4. To remove, first
5. Pull up front of adapter,
remove small cartridge
then lift it out.
from adapter.
3. Close clamp, slide
carriage to one end,
punch. Make sure to
push lever completely
down.
4. Slide carriage to lock-in 5. Lift magnetic clamp to
slot, punch, and
remove paper.
repeat.
How to use AdvantEdge™ Punch:
1. Insert cartridge,
position carriage
in middle.
2. Lift magnetic clamp,
slide paper all the way
to the back of
cartridge.