how to use artcut in contour cutter.cdr

1、Connect the cutting plotter, switch on the power.
2、Put the driver CD (vinyl cutter)
3、press next
Press finish
Double click artcut2009
Press create
Press file
Press open
Press open
Press file
Press cut/plot...
1、Press foison
2、press foison c24
3、press setup
Tick the box of close
1、Input 0. 45mm in the box of close
2、Input 0. 35mm in the box of Sharp Augle
3、Choose High for plotting accuracy.
4、press ok
Press yes
1、Choose FOISON
2、Choose FOISON C24
3、Press add
Press close
Choose the port number, it has to be same as the device manage
port setting, please check the file (name is device manage port
setting) for how to set up.
Press setup
Press parameters
Choose 38. 4k for Baud rate
Only tick the box of xon/xoff in Sequential control
Press ok
Press change
Press cancel
Press cut/plot
Press start