purex protect plus

PUREX PROTECT
PLUS
PRODUCT:
Phosphoric Acid / Vinyl Copolymer
USAGE IN:
Inground and aboveground pools
and spas
PURPOSE:
For the control, removal and prevention
of staining in pools and spas
WHEN TO USE:
When noticing calcium build up or
stains on pool surface
DIRECTIONS FOR USE:
Distribute straight from bottle
around pool with filter running.
COMMENTS:
Refer to label for dosages
AVAILABLE SIZES:
1 litre
6/1
PUREX SAND FILTER
CLEANER
PRODUCT:
Sulphamic Acid & Surfactants
USAGE IN:
Inground and aboveground pools
PURPOSE:
To clean and maintain sand filter
to run efficiently
WHEN TO USE:
When sand filter is not running at
100% capacity
DIRECTIONS FOR USE:
Backwash filter, then distribute
through skimmer box with filter running
COMMENTS:
For removal of substances that
backwash cannot remove eg. hair,
body fats, sunscreens and calcium
scaling. This product is excellent for
rejuvination of old sand.
Refer to label for dosages
AVAILABLE SIZES:
1 kg
6/2
PUREX CARTRIDGE
FILTER CLEANER
PRODUCT:
Mineral Acid / Biodegradable Surfactants
USAGE ON:
Cartridge Filter
PURPOSE:
To degrease and clean cartridge
WHEN TO USE:
When cartridge is soiled and dirty,
causing pressure build up in filter
DIRECTIONS FOR USE:
Fill a large bucket/receptical with approx.
40 litres of water – add 1 litre of
product. Remove cartridge and soak
overnight, then hose clean
COMMENTS:
For best results ensure cartridge is fully
immersed. Rotate or turn cartridge over
in solution if necessary
AVAILABLE SIZES:
1 litre
6/3
PUREX OXY
BOOST
PRODUCT:
Peroxygen Compound
USAGE IN:
Inground and Aboveground Pools
and Spas
PURPOSE:
A non chlorine based shock agent.
It oxidizes in the water allowing water
to sparkle.
WHEN TO USE:
After pool or spa has heavy use.
DIRECTIONS FOR USE:
Add direct to water with filter running.
COMMENTS:
A great way to shock water without
over chlorinating. Oxy Boost converts
saltwater into liquid chlorine, greatly
assisting the salt water chlorinator.
Refer to label for dosages.
AVAILABLE SIZES:
1kg, 4kg, 10kg
6/4
PUREX SAND
FILTER AID
PRODUCT:
Diatamaceous Earth with Cellulose
USAGE ON:
Sand Filters
PURPOSE:
Helps the filter to filter to the
finest micron
WHEN TO USE:
Cloudy water or fine particles
which are stubborn to remove
DIRECTIONS FOR USE:
Backwash filter, pour through
skimmer with filter running for
24 hours or until clear then
backwash. Repeat if necessary.
COMMENTS:
Refer to label for dosages
AVAILABLE SIZES:
1 kg
6/5
PUREX SALT CELL
CLEANER
PRODUCT:
N.O.S. Corrosive Liquid/ Phosphoric
Acid / Organic Surfactants
USAGE IN:
Salt electrodes
PURPOSE:
To remove calcium build up from
salt cell
WHEN TO USE:
When calcium builds up on cell
DIRECTIONS FOR USE:
Pour salt cell cleaner into
container, submerge cell until
calcium softens and hose off
COMMENTS:
Product is designed to be used
at full strength, DO NOT DILUTE
AVAILABLE SIZES:
5 litre
6/6
PUREX CAL. KILL
PRODUCT:
Magnesium Sulphate
USAGE IN:
Inground and Aboveground pools
PURPOSE:
Helps prevent leeching & corrosion of
pool walls & surfaces, lowers calcium
levels in pool water, hence increasing Salt
Cell life and efficiency.
WHEN TO USE:
When calcium levels are high, also use
when noticing rapid and hard calcium build
up on electrode.
DIRECTIONS FOR USE:
Mix with water in bucket and distribute
evenly around pool with filter running.
COMMENTS:
Refer to label for dosages
AVAILABLE SIZES:
4kg
6/7
PUREX METAL
OUT
PRODUCT:
Tetrasodium Salt
USAGE IN:
Inground and aboveground pools
PURPOSE:
Removal of metals eg. iron, copper
and magnesium as a preventative
against staining
WHEN TO USE:
Recommended on newly filled
pools or in areas of bore water
DIRECTIONS FOR USE:
Dissolve in a bucket and distribute
evenly around pool with filter running
COMMENTS:
Refer to label for dosages
AVAILABLE SIZES:
1kg
6/8
PUREX STAIN
REMOVER
PRODUCT:
Organic Acids
USAGE IN:
Inground and Aboveground Pools
PURPOSE:
To remove leaf & metal stains eg. plating
WHEN TO USE:
When stains such as plating or leaf
stains are visible.
DIRECTIONS FOR USE:
Drop chlorine below 1ppm.
Turn filter off. Add stain remover to affected
area where possible. Leave filter off for 24
hours. No swimming, then superchlorinate
and adjust pH where necessary.
COMMENTS:
Refer to label for dosages
AVAILABLE SIZES:
1kg
6/9
PUREX D.E
BOXED
PRODUCT:
Diatomaceous Earth
USAGE IN:
D.E. Filter and Sand Filters
PURPOSE:
To coat filter element and collate fine particles
WHEN TO USE:
After every backwash with DE filter,
with sand filter use to enhance filter
performance
DIRECTIONS FOR USE:
Add to skimmer basket with filter running
COMMENTS:
Refer to label for dosages
AVAILABLE SIZES:
4.54kg, 11.35kg
6/10
PUREX PHOSPHATE
REMOVER & ALGAE
GROWTH INHIBITOR
PRODUCT:
Lanthanum Chloride
USAGE IN:
Inground and aboveground pools, ponds &
aquariums.
PURPOSE:
To lower Phosphate levels in pool water
& keep your pool phosphate free. Inhibits
the growth of algae.
WHEN TO USE:
Every 2-3 days.
DIRECTIONS FOR USE:
Pour slowly through pool skimmer box
with filter running.
COMMENTS:
Compatible with ALL pool chemicals.
Refer to label for dosages.
Completely soluble.
Safe to use with cartridge filters.
AVAILABLE SIZES:
1 litre, 2.5 litre, 5 litre, 25 litre
6/11
PUREX TILE &
VINYL CLEANER
PRODUCT:
Alkaline salts
USAGE ON:
Pool and spa covers, pool and spa tiles,
BBQ's, outdoor furniture and tiled floors
PURPOSE:
To maintain and clean healthy pool
and spa surrounds
WHEN TO USE:
When mould or mildew appear on surfaces
DIRECTIONS FOR USE:
Apply Purex Tile and Vinyl Cleaner direct to
the area to be cleaned. Rub briskly with a
sponge or cloth, then simply wash off with
water
COMMENTS:
Use regularly to keep furniture etc
in good condition
AVAILABLE SIZES:
750ml
6/12