How to use Quanti-Tray and Quanti-Tray /2000

Transcription

How to use Quanti-Tray and Quanti-Tray /2000
How to use Quanti-Tray and
Quanti-Tray /2000
®
®
Quantification method for Colilert , Colilert -18,
Colisure and Enterolert™
®
®
®
4
1
Open snap pack
and add the reagent
to 100 mL of water
sample in a sterile
vessel.
2
Squeeze the
upper part of the
Quanti-Tray so that
it bends towards
the palm.
Incubate according
to the appropriate
IDEXX reagent’s
product insert.
5
Open the Quanti-Tray
by pulling the foil
tab away from the
well side.
Pour the reagent/
sample mixture
directly into the
Quanti-Tray.
Read each result
by comparing
it against the
Quanti-Tray
Comparator.
Count positive
wells and refer
to the MPN table.
Refer to each
product insert for
specific reading
instructions.
Avoid contact with
the inside of the
Quanti-Tray.
3
Place the samplefilled Quanti-Tray
onto the rubber insert
of the Quanti-Tray
Sealer with the well
side (plastic) of the
Quanti-Tray facing
down to fit into the
rubber insert.
For more information, visit
www.idexx.com/water
or call 1-800-321-0207
Seal according to the
Quanti-Tray Sealer
instructions.
© 2009 IDEXX Laboratories, Inc. All rights reserved. • 09-71166-01
Quanti-Tray, Colilert, Colisure and Enterolert are trademarks or registered trademarks of IDEXX Laboratories, Inc. in the United States and/or other countries.
ISO 9001 2000 CERTIFIED