Subsystem How to enter subsystems in SOLARWHIN data entry

Transcription

Subsystem How to enter subsystems in SOLARWHIN data entry
Subsystem
How to enter subsystems in SOLARWHIN data entry
Subsystem is used to enter the split up capacity of a
system installed by using different capacities. Please see
the following examples.
Those who enter the data in SOLARWHIN might have
seen a field namely ‘No. of subsystems in a System’.
It is found that actual purpose of this field is not clear to
all. So I am explaining it separately for the purpose of
correct entry. You may please go through it and still you
have doubt please call on 011-24361891 before making
wrong entry.
MNRE wants to gets the record of actual installation.
1. Consider the following example.
One company installed a system with capacity
105000lpd. It consists of 105 numbers of 1000lpd
systems. So when you enter the case it should enter as
follows.
Solar water heater total capacity: 105000lpd
Number of subsystems in the system: 105
…
After submission it will ask for the subsystem details for
entry. At that time you have to enter the details as
follows.
Corresponding to the actual capacity enter
=================================
Capacity
Number
Area
100
125
150
..
200
..
900
1000
105
Area
1050
..
6000
10000
The area entered should be matched with the total
number of pipes selected in the main screen.
If you enter the case as follows.
Solar water heater total capacity: 1000lpd
No. of systems = 105
Number of subsystems in the system: 0
This entry is wrong.
-----------------------------------------------------------Now consider the following example.
Solar water heater total capacity: 700lpd
No. of systems = 1
Number of subsystems in the system: 5
Collector area = 12.50
Subsystem details
100
1
2.50
4
10.00
125
150
..
200
If you enter the data correctly then when we take MIS
report at National level it will be correct. Due to the
above entry (first case), though they installed 105000lpd
system in our reports it is not reflecting because of wrong
entry.
Please avoid such errors. Also now a day we
found that the most of the errors coming is the
capacity entry. Those who enter the data enter any
value like 1, 2 , 3 or 10 or 54 or like that in the
capacity field. Here they enter either cost of the
system or number of systems. So please correct the
entry if you made mistake on the same day or next
day itself by taking daily entry list.
For any clarification please feel free to call to 01124361891 or through email: [email protected]
Saji K Abraham
Technical Director (NIC)
011-24361891
[email protected]