MHT VL TYPE BULB INSTRUCTION MANUAL

Transcription

MHT VL TYPE BULB INSTRUCTION MANUAL
MHT LIGHTING
MHT-VL
MHT VL TYPE BULB INSTRUCTION MANUAL
MHT VL Type Induction Bulb includes two different structures, intermediate
exhaust tube for 12W-120W and bottom side exhaust tube for 150W-250W.
12W-120W VL Bulb Installation and Removal
1. The structure of 12W-120W VL Bulb has a long glass tube (Exhaust Tube) in
the center of the bulb that needs to be inserted into the top hole on magnet.
Top hole on magnet
12-120W VL Bulb
Exhaust Tube
2. Because of the special structure of bulb, installation and removal require
special care in order to prevent damage of Glass Tube.
Move the bulb down
to the bottom of
magnet slowly
Glass Tube must be
aligned before it is
inserted into the
top hole on magnet
Fig. 2
www.MHTLIGHTING.com
MHT LIGHTING
MHT-VL
3. Make sure the bulb is all the way down before turning it clockwise and is
locked properly and tight.
The two red dots on the
following should be
fully fit to mount
Move the bulb till it
gets all the way down
Turn the bulb clockwise
when it is in place
4. Bulb Removal.
Remove the bulb by turning
it counter-clockwise
Fig. 4
www.MHTLIGHTING.com
MHT LIGHTING
MHT-VL
150W-250W VL Bulb Installation and Removal
1. For 150W-250W VL Bulb, Glass Tube is on the bottom of the bulb and there
has no hole on top of the magnet.
No hole
Glass Tube
2. Move the bulb all the way down slowly and lock it tight.
Rotate the bulb
clockwise and
lock it tight
Align the bulb to magnet
and move the bulb all the
way down slowly
图6
图7
3. Remove the bulb by rotating it counter-clockwise.
www.MHTLIGHTING.com