Risk Assessments School of Physics How and what

Transcription

Risk Assessments School of Physics How and what
Risk Assessments
How and what
School of Physics
Risk Assessments
• You have carefully thought out all the angles
• You have done it a hundred times
• It comes naturally to you
• You know what you are doing, it is what you have been
trained to do all your life
• So nothing could possibly go wrong
• Could it ??
Think Again!
No beavers were actually injured
during the creation of this
PowerPoint presentation!
Risk Assessment
“A systematic evaluation of
the work place and/or other
activities which identifies the
hazards present and gives
an estimate of the extent of
the risks involved”
Risk Assessment – The History
•Always been here
•Concept introduced with the Health
and Safety at Work Act 1974
•Concept expanded upon in the
Management of Health and Safety
Regulations 1992 (1999)
•Integral to all other appropriate
legislation i.e. CoSHH, PPE, Noise etc
So what is the concept of Risk
Assessment?
Hazard
Anything that
may cause
harm
Risk
The probability of harm
occurring
Chance of exposure to the hazard
X
Consequences (severity)
Task or Area Based ?
Area Based
• Normally used for identifying common
hazards in the workplace
• Will also be used to identify TASKS to be
individually risk assessed
Area Based Example
A risk assessment of administrative areas will lead to the
identification of the following hazards:
Slip, trips and falls
Electrical Safety
Computer workstation hazards
Manual Handling
Area Based Example
• The common hazard of slips trips and falls can be
dealt with through the School policy.
• The electrical safety will also be School policy with
regard to inspection and PATesting.
• Manual handling and the computer work stations will
have to be risk assessed on a task basis.
Task Based
• A specific task or job will be risk assessed
• All the hazards associated with the task will be assessed
electrical
biological
chemical
radiation
manual handling
falls from height, etc
5 Steps To Risk
Assessment
Step One
Identify the
hazards
Methods Of Identifying
Hazards
•
•
•
•
•
•
•
Health & safety audits
Academic journals
Research papers
Consultation with other co-workers
Accident reports
Trade organisations
HSE statistics
Methods Of Identifying Hazards
• Similar Institutions
• Outside Advice (manufacturers of
equipment and materials)
• Internal Advice (University Safety &
Health Services)
Step Two
Identify who
might be
harmed
Who Might Be At Risk
•Employees
•Contractors
•Visitors
•General public
•Children
•People who share
the workplace
•Must be people specific
Don’t forget vulnerable groups such as people with
disabilities, pregnant staff and those with little
experience or training.
Step Three
Evaluate the risks
Risk Analysis
• Hazards and
hazardous situations
are systematically
identified.
• The level of risk
associated with
each hazard
(situation) is
estimated
Risk Evaluation
• A judgement is made as
to whether the level of
risk is acceptable or
tolerable
• Will include a judgement
on corrective or
preventative measures
Completing the Risk assessment
Organising actions and responsibilities to reduce
the hazards and risks to acceptable levels:
 Elimination of hazard (do I have to do this?)
 Substitution (materials, equipment etc)
 Physical safeguards (machinery guarding, extraction
etc)
 Personal Protective Equipment
 Safe working procedures
 Or any combination of above
Completing the Risk assessment
Writing safe working procedures or
instructions
General procedures may be in local rules
Specific procedures must be included in the
risk assessment
Evaluating The Risks
-some considerations
•
•
•
•
•
•
•
•
•
Industry standards
Legal requirements
Precautions already taken
Cost (so far as is reasonably practical)
Different working conditions i.e. weather
Numbers of people at risk
Severity of injury
Probability
Length of exposure/frequency
Step Four
Record your
findings
Recording the Risk Assessment
The Elements
 A description of the area or task
 The hazards that personnel may be exposed to
 Details of the personnel who may be exposed to the
hazards
Recording the Risk
Assessment
 Details of which hazards are significant and those
which are acceptable (and why)
 The precautions in place, or to be put in place, to
reduce the significant hazards to acceptable levels
 How the precautions are to be maintained
(management of systems, inspection of physical
precautions etc)
Recording the Risk
Assessment
• Details of additional risk assessments i.e. hazardous
substances (COSHH)
• Emergency Procedures
• Details of person completing the risk assessment
• Details of person countersigning the risk assessment
• Date, school or group, location details etc.
Recording the Risk Assessment
Evaluate the risks
•
•
•
•
•
•
Use the risk matrix on the form
Estimate the risk before control measures
Identify control measures to lower the risk
Estimate the risk after control measures (residual risk)
Can you lower the risk further? Ideally all LOW
Not all risks are injury – what about financial loss?
Recording the Risk Assessment
Consequence
L
i
k
e
l
i
h
o
o
d
Minor injury or no
apparent injury
Injury requiring first aid
Injury requiring
medical treatment, or
with possible long
term negative health
effects
Will probably not
occur in most
circumstances
Low
Low
Medium
May occur in some
circumstances
Low
Medium
High
Likely to occur in
most
circumstances
Medium
High
High
Recording the Risk Assessment
Signatures
•
•
•
all Low Risk - Principal Investigator (YOU). If not
competent to do so, then also a Competent Person
any Medium Risk - Principal Investigator and
Competent Person (not the same)
any High Risk – PI and CP, then referred
to Head of School and Safety Manager
for formal authorisation
School of Physics Policy
• Use standard School risk assessment form or
Specific RA form for hazards like lasers
• Must be readily available in the laboratory on paper
• Must be appropriately signed
• Review at least annually or on changes
• Copy provided to Head of Group and School
Safety Manager
• Work not covered by a suitable and
sufficient risk assessment can be stopped
by SSA, HoS, SSM, University Safety & Health Services or HSE.
School of Physics
COSHH / Risk Assessment
Title:
Ref:
Name of Principal Investigator
Description of Task / Activity (including frequency / duration)
Location
Names/Type of Persons Involved / At Risk
Should the personal circumstances (such as pregnancy or any other medical condition) of any person
involved change, this risk assessment MUST be reviewed.
Hazards
Activities, substances,
machines, tools, etc.
Hazards identified
Estimated risk
(low/medium/high)
1.
2.
3.
4.
5.
Precautions required to mitigate risk (relate to numbers above):
Estimated risk
after
precautions
(low/medium/high)
1.
2.
3.
4.
5.
Emergency Procedures and Contacts
Lone / Out-of-Hours Working
Training Requirements
Access Restrictions / Signage
Storage
Waste Disposal
Principal Investigator
Competent Person
(in all cases)
Signature
Date
(medium / high risk)
Signature
Date
Date for Next Assessment (must be reviewed within 12 months)
Step Five
Review the assessment
Legal Summary
The Management of Health and Safety at Work
Regulations 1999 (amended 2006)
Risk assessment
3.—(1) Every employer shall make a suitable and sufficient assessment of—
•
•
(a) the risks to the health and safety of his employees to which they are exposed whilst
they are at work; and
(b) the risks to the health and safety of persons not in his employment arising out of or
in connection with the conduct by him of his undertaking,
for the purpose of identifying the measures he needs to take to comply with the requirements
and prohibitions imposed upon him by or under the relevant statutory provisions and by Part
II of the Fire Precautions (Workplace) Regulations 1997.
Risk Assessment Strategy
1. Identify the hazards
2. Evaluate the risks
3. Detail the control measures
required to eliminate or reduce
to risks to acceptable levels
Summary
Recording the significant findings of the risk
assessment.
 What the task is
 Who is responsible/supervisor
 Where the risk assessment applies, who is affected
 List of hazards
 List of precautions
 Details of safe working procedures
 Emergency procedures
 Reference to other associated risk assessments i.e.
COSHH, manual handling, PPE etc.
Summary
Organising actions and responsibilities to
reduce the hazards and risks to acceptable
levels:
 Elimination of hazard
 Reduce by substitution (materials, equipment etc)
 Physical safeguards (machinery guarding,
extraction etc)
 Personal Protective Equipment
 Safe working procedures
 Combination of above
How it can go wrong –
a Case Study
The Health and Safety Executive have
inspected part of the University following
a case of occupational asthma and
issued the University with an
“Improvement Notice” to improve RISK
ASSESSMENTS!!!
Circumstances of the
Improvement Notice
• Project studying poultry in various locations (approx 12
years)
• Member of staff involved in project never used
respiratory protection or considered exposure to animal
allergens
• Member of staff developed asthma which was later
diagnosed as “occupational asthma” i.e. directly
connected to the work environment
Circumstances of the
Improvement Notice
• Details reported to the HSE (legal requirement)
• HSE investigated and concluded that the risk
assessment for the work undertaken was not “suitable
and sufficient”
(Reg 3 of The Management of Health and Safety at Work Regulations 1999)
and served improvement notices under the HASAW
1974 and COSHH Regs 1999
Circumstances of the
Improvement Notice
• The risk assessment for the activity did not consider the
possibility of occupational asthma due to exposure to
animal allergens, a condition that was foreseeable
• No respiratory protection was considered or provided
and no lung function tests were ever carried out
(although available)
Circumstances of the
Improvement Notice
• The HSE concluded that although the person involved
was working on an individual project, the management of
the University should have ensured that appropriate
precautions were taken.
They also concluded that there was no effective risk
management system and that similar hazards may not
have been addressed.
Other Possible Outcomes
The HSE considered a prosecution,
which would have probably been
successful. In the circumstances
they felt that the willingness of the
University to improve its systems
meant that an “Improvement Notice”
would serve the interest of health
and safety better.
Examples
• Insured losses
 Compensation claims (UV burns £116k)
(Back Injury £33k)
 Loss of business etc??
• Uninsured losses
 Fines of up to £20k, but last time……….
» Fines (£3k)
» Costs (£7k prosecution, £10k defence)
(£20k) from School resources !
The “cost” of Discharging the
Notice
The following is a breakdown of the hours spent
discharging the Notice:
 School Safety Advisor
– 460 Hours
 Divisional / Area Safety Advisors (6) – 1700 Hours
 School Staff
- 2800 Hours
 Total:
4960 Hours or 124 working weeks
Case Study
• Ordered Conc. Sulphuric acid from a dubious but cheap
supplier
• Arrives on a wooden & damaged pallet, glass
winchesters loosely secured by shrink film.
• Left on loading bay and needs moving to the stores for
safety.
• Pallet appears to be damp in places.