2430 - UKAS
Transcription
2430 - UKAS
Schedule of Accreditation issued by United Kingdom Accreditation Service 21 - 47 High Street, Feltham, Middlesex, TW13 4UN, UK Odournet UK Ltd Issue No: 015 2430 Issue date: 24 December 2014 5 St Margaret's Street Contact: Ms L Sutton Bradford-on-Avon Tel: +44 (0)1225 868869 Wiltshire Fax: +44 (0)1225 865969 BA15 1DA E-Mail: [email protected] Website: www.odournet.com Accredited to ISO/IEC 17025:2005 Testing performed by the Organisation at the locations specified below Locations covered by the organisation and their relevant activities Laboratory locations: Location details Activity Location code Odour concentration measurement including sample pre-dilution A Odour concentration measurement including sample pre-dilution B Location details Activity Location code Customer Sites Sampling (teams from Bradford-on Avon and Altrincham) C Address 5 St Margaret’s Street Bradford-on-Avon Wiltshire BA15 1DA Local contact Ms L Sutton Address 8 Vale View Vicarage Lane Bowdon Altrincham WA14 3BD Local contact Ms L Sutton Tel: +44 (0)1225 868869 Fax: +44 (0)1225 865969 Email: [email protected] Website: www.odournet.com Tel: +44 (0)161 929 6778 Fax: Email: [email protected] Website: www.odournet.com Site activities performed away from the locations listed above: Assessment Manager: JY Page 1 of 4 S c he dul e of Ac c r e di ta ti on issued by United Kingdom Accreditation Service 21 - 47 High Street, Felt ham, Mi ddl esex, TW 13 4UN, UK 2430 Odournet UK Ltd Accredited to Issue No: 015 Issue date: 24 December 2014 ISO/IEC 17025:2005 Testing performed by the Organisation at the locations specified DETAIL OF ACCREDITATION Materials/Products tested Ambient Air Process Emissions Surface Emissions Stack Gas Samples Type of test/Properties measured/Range of measurement Location Code Documented In-House Procedures QD01 and QD02 based on BS EN 13725:2003 by dynamic olfactometry A, B National, European, International and other recognised standards using documented In-House work instructions C Sensory Tests Odour concentration measurement including sample pre-dilution Ambient Air Process Emissions Surface Emissions Standard specifications/ Equipment/Techniques used Sampling Collection of odour samples for delayed olfactometry Documented In-House Procedures QD018 and QD019 based on BS EN 13725:2003 Point source sampling using: - Lung method - Pre-dilution Area source sampling with outward flow using: - Sheet Method Area source sampling without outward flow using: - Lindvall Hood Method - Inverted Lindvall Hood Method - Sheet Method Assessment Manager: JY Hydrogen Sulphide Sampling direct from source or sample bag onto activated carbon using in-house procedure QD024 based on BS EN 13649:2002 C Ammonia Sampling direct from source or sample bag by desorption onto silica gel using in-house procedure QD024 based on NIOSH 6016 C Page 2 of 4 S c he dul e of Ac c r e di ta ti on issued by United Kingdom Accreditation Service 21 - 47 High Street, Felt ham, Mi ddl esex, TW 13 4UN, UK 2430 Odournet UK Ltd Accredited to Issue No: 015 Issue date: 24 December 2014 ISO/IEC 17025:2005 Testing performed by the Organisation at the locations specified Materials/Products tested Testing of Stack Emissions to Atmosphere Assessment Manager: JY Type of test/Properties measured/Range of measurement Standard specifications/ Equipment/Techniques used Location Code Sampling with subsequent analysis at an ISO/IEC 17025 accredited laboratory National, European, International and Environment Agency specified standards and documented inhouse work instructions to meet the requirements of DD CEN/TS 15675:2007 and BS EN 15259:2007 Ammonia Sampling direct from source or sample bag by desorption onto silica gel using in-house procedure QD024 based on NIOSH 6016 C Pressure, Temperature and Velocity ISO 10780:1994 (QD019) by Pitot tube C Velocity ISO 10780:1994 (QD019) by hot wire anemometer for gas velocities below 5 m/sec C Sampling with subsequent analysis at an ISO/IEC 17025 accredited laboratory National, European, International and Environment Agency specified standards and documented inhouse work instructions to meet the requirements of DD CEN/TS 15675:2007 and BS EN 15259:2007 and the Environment Agency (MCERTS) Performance Standard where required Ammonia BS EN 14791:2005 (Method QD025) C Aldehydes Amines and amides Arsine Carbon disulphide Carboxylic acids Hydrogen sulphide Mercaptans Methanol Phenols and cresols Phosphorous and its inorganic compounds Siloxanes VOCs (speciated) BS EN 13649:2002 (Method QD024) C Page 3 of 4 S c he dul e of Ac c r e di ta ti on issued by United Kingdom Accreditation Service 21 - 47 High Street, Felt ham, Mi ddl esex, TW 13 4UN, UK 2430 Odournet UK Ltd Accredited to Issue No: 015 Issue date: 24 December 2014 ISO/IEC 17025:2005 Testing performed by the Organisation at the locations specified Materials/Products tested Type of test/Properties measured/Range of measurement Standard specifications/ Equipment/Techniques used Location Code Testing of Stack Emissions to Atmosphere (cont’d) Sampling with subsequent analysis at an ISO/IEC 17025 accredited laboratory National, European, International and Environment Agency specified standards and documented inhouse work instructions to meet the requirements of DD CEN/TS 15675:2007 and BS EN 15259:2007 and the Environment Agency (MCERTS) Performance Standard where required Odour (direct sampling of dry stacks and dynamic dilution sampling of hot wet stacks) BS EN 13725:2003 (QD018) C Bioaerosols VDI 4257 part 2:2011 (Method QD023) C BS EN 14790:2005 (Method QD023) C BS EN 16911-1:2013 (Method QD019 using differential pressure device (pitot tube) method) C Sampling and On-Site Analysis Water vapour Sampling and On-Line Analysis Pressure, Temperature and Velocity (Point Velocity Method) END Assessment Manager: JY Page 4 of 4