Commercial Replacement Door Worksheet

Company:
Contact:
Job Name:
Mark #:
TRUDOOR, LLC
4737 N. 43RD AVE #6 PHOENIX, AZ 85031
P: (623) 748-9122 F: (623) 547-7052
[email protected]
Email Address:
Phone Number:
Fax Number:
Replacement Door Worksheet
A
DOOR TYPE: _____ HOLLOW METAL, 18 GA.
_____ SOLID CORE WOOD (VENEER: ____________ )
_____ OTHER: ___________________
C
___________________ A. INSIDE DIMENSION OF FRAME WIDTH (e.g. 36”)
D
Measure from
the inside of the
frame head, to
the top of each
hinge cutout
___________________ B. ACTUAL DOOR HEIGHT (e.g. 83 1/8”)
G
___________________ C. UNDERSIDE OF FRAME HEAD TO TOP OF HINGE CUTOUT #1
F
E
H
B
Note: 8’0” doors
have a 4th hinge
(not shown on
drawing).
Write 4th hinge
dimension in the
notes/additional
info box.
___________________
___________________
___________________
___________________
___________________
___________________
___________________
___________________
D. UNDERSIDE OF FRAME HEAD TO TOP OF HINGE CUTOUT #2
E. UNDERSIDE OF FRAME HEAD TO TOP OF HINGE CUTOUT #3
F. UNDERSIDE OF FRAME HEAD TO C/L OF FRAME LOCK PREP
G. UNDERSIDE OF FRAME HEAD TO C/L OF DEADBOLT CUTOUT
H. LOCK BACKSET (e.g. 2 3/4” or 2 3/8”)
I. DOOR THICKNESS (e.g. 1 3/4” or 1 3/8”)
J. HINGE HEIGHT (e.g. 4 1/2”)
K. DOOR HAND
FIRE RATING:_____ 20 _____ 45 _____ 60 _____ 90 _____ 3 HR
LITE KIT (EXPOSED GLASS): _____ NONE _____ 10” X 10”
Measure from
the inside of the
frame head, to
the center-line
of the strike or
lock cutout
_____ 5” X 20” _____ 4” X 25” _____ 22” X 28” HALF GLASS
_____ FULL GLASS OTHER: _________________________________
LOUVER SIZE: _____ NONE _____ 12” X 12” _____ 12” X 24”
Typical Undercut: 3/4” or 5/8”
_____ 24” X 24“ _____ FULL LOUVER _____ OTHER:_____________
K
RH
OUTSIDE
(KEYSIDE)
RIGHT HAND
RHR
OUTSIDE
(KEYSIDE)
RIGHT HAND REVERSE
HARDWARE: _____ HINGES (TYPE:______________ )
LH
I
_____ LOCKSET (FUNCTION:____________ ) _____ DEADBOLT
_____ PANIC BAR (TRIM:____________ ) _____ DOOR CLOSER
_____ PUSH/PULL SET_____ LATCH GUARD _____ KICKPLATE
_____ THRESHOLD_____ WEATHERSTRIP _____ DOOR SWEEP
_____ DRIP CAP_____ WALL/FLOOR STOP _____ DOOR VIEWER
OUTSIDE
(KEYSIDE)
LH - LEFT HAND
LHR
OUTSIDE
(KEYSIDE)
LEFT HAND REVERSE
The hand of a door is always determined from the outside.
J
HARDWARE FINISH: _____ US26D _____ US32D _____ US4
_____ US3 _____ US10_____ US10B _____ OTHER: _____________
NOTES / ADDITIONAL INFO: _______________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
© Trudoor, LLC | 10/2014