45LT-CN Series

45LT-CN Series
Torque ajustment screw side
Sticker side
Torque ajustment screw
Terminations
BLACK GRAY GREEN
YELLOW BLUE RED
Torpue ajustment screw
Lineups
Torque up (CW) , Torque down (CCW)
Plea se turn it by light power.
Plea se employ an M2 Phillip s driver.
Heavy, and a place to fall into i s the limit of the turn.
CF-45LT-CN1
-
Cross fader
Vestax PMC 05 06 07 007
-
* Installation plate and knob are not included.
How to use
Specifications (Fader)
CF-45LT-CN1
M3 Sc rew
Installation plate
2LPA-4805LT-B50K
Number of circuit
Total resistance
Total resistance tolerance
Taper
Linearity
Residual resistance
Voltage proof
Insulation resistance
Max rating
Sliding noise level
Sticker side
Torque aju stment screw side
GRAY
RED
YELLOW
GREEN
BLACK
BLUE
TOKYO KO-ON DENPA CO., LTD.
GRAY and RED
YELLOW
GREEN
BLACK and BLUE
1. Adjust it to favorite torque.
2. Fix an installation plate to the fader with an M3 screw.
3. Connect the connector of the mixer and a connector of CF-45LT.
4. Put fader in a mixer and fix it with a screw.
5. Cover with the face panel of the mixer.
6. Attach a knob.
*An installation board, a screw, a knob are things using now, or,
please prepare separately.
www.tkd-corp.com EDF-201502 The products and their specifications are subject to change without notice.
Sliding life
Stroke length
Operating force
Strength of Nut-Attached
Attached Parts
Stopper strength
Push-pull strength
Temperature range
Relative humidity
2
50kohm (Red-Blue, Black-Gray)
±20%
Linear (Potentiometer circuit)
±5%
5ohm or less
Red-Yellow, Blue-Yellow
Black-Green, Gray-Green
1 Min. at AC500V
50Mohm or more at DC250V
DC20V
47mV or less (by JIS C 6443)
100,000 Cycles Min.
Cycle speed: 18cycles/min
Sliding noise level: Less than 100mV
45mm±0.5mm
0~0.5N (Torque adjustment screw)
100Ncm
M3 screw
50N
50N
-10 to +60 degrees C (Operating)
-15 to +65 degrees C (Storage)
80%RH (No condensation)