Infinitybox Generic Car Schematic

Wht-Red
Reverse light
Switch
(Optional)
Blu-Grn
White-Black
Blue-Yellow
If alternate
DPDT switch is
used for lights,
connect this
lead to Park lug
on switch
Horn
White-Green
Headlights
Blue-Red
High Beams
Optional One Button
Ignition/Start
Blue-Black
White-Yel
Parking
White-Blue
Ground From MASTERCELL
Mastercell Section
Notice
Button of Choice
ACC IGN Start
All wires are Mastercell switch
circuits and are switched to
ground. Application of battery
voltage will result in serious
damage to the ISIS system and
void your warranty.
Input 39
Tan-Green
Ground wire from
MASTERCELL
+
Ground any inputs that
you only want to be active
with ignition through the
ignition terminal.
No other ignition or starter switch needed when using
the One Button personality
DOTTED LINE = Control
Circuits that are wired to be
enabled only when ignition is
on
Use this as
ground for
Accessory
Switched Inputs
All inputs not grounded
through the terminal will be
active even if the car is off.
Ignition-On Functions Using One Button Start
Ground wire
from
MASTERCELL
See supplementary
diagram if using the One
Button Start
“CAN” Cable
#2 Battery Cable
“CAN” Cable
Connector
To Powercell #1
Mastercell Schematic color
key:
Battery
“A” Connector
MEGA FUSES
Note: Make wire
from the battery to
the fuses as short
as possible
Front
Rear
2
“B” Connector
1
If the starter has an
integrated solenoid, the
remote starter solenoid is
not necessary and wire
from the POWERCELL
to the contacts of the
starter solenoid.
Fan thermo
switch
Splice into output 3
from POWERCELL 1
and Ignition Powered
Device (ECU, Dash,
MSD, etc.)
S
CAN Cable
GREEN = Control Circuits that
are always enabled
Lt Blue-Brown
Hazards
Note: Turn signal wire colors
shown are for multifilament bulbs
with a mechanical column. See
programming for self canceling
and one filament options.
Pink-Green
BLACK = Control circuit
ground connections
Refer to programming for
actual wire and tracer colors
Brake
Switch
Input wire to
MASTERCELL
Connect to open
input(s) whose output
should come on with
ignition
Use as ground
for switches that
are only active
when ignition is
on
Lt. Blue-Black
Right Turn
Wire size guidelines:
The components are shown in relative positions, but have been spaced for clarity. The Megafuses
should be placed as close to the battery as possible to minimize unprotected wire. All of the battery
cable and heavy wire runs should be kept as short as possible and should be protected from chaffing
or mechanical damage.
S
I
Clutch/Neutral
Safety Switch
Purple-Right Rear Turn Signal
Lt. Green-Brake Light
To Ignition System or
ECM Per
Manufacturer
Lt. Green-Ignition (or ECU), Electric Choke, Gauges
If using wipers,
run them through
the factory wiper
switch
Purple-Right Front Turn and Indicator
Battery to Starter
Battery to Megafuse
Megafuse to Front Powercell
Megafuse to Rear Powercell
Alternator to Megafuse
Remote relay to Start Solenoid
Be sure to use a ground strap or braided cable, of the same gauge or heavier than the positive cable,
from the battery to the frame. It should be securely attached to a welded or threaded stud, and the
ground path must not be interrupted by paint or powdercoat. A secondary ground cable (#4 Ga. Or
heavier) should be run from the engine block to the frame. Finally, if your alternator has a tapped
boss on the rear cover, attach a ground cable (#8 Ga. or heavier) using a short bolt and attach it to
the cylinder head. Each Powercell ground (see Powercell schematic) should be securely attached to
the frame as close to the Powercell as possible.
Brown-Left Rear Turn Signal
Lt. Blue – Starter Solenoid
1-wire
Alternator
Lt Blue-Red
Left Turn
White- Headlights
Starter
Remote
starter
solenoid
2 AWG (minimum)
4 AWG (included)
2- 8 AWG (included)
2- 8 AWG (included)
8 AWG
10 AWG
See programming chart for
1 filament wiring
Lt. Blue - OPEN
Turn Indicator
White- Reverse Lights or OPEN
Brown-Left Front Turn and Indicator
Turn Indicator
Black-To Chassis Ground
Black-To Chassis Ground
Headlights- 15
Turn Signals- 10
Tail Lights- 10
Engine Fan- 25
Heater/Wipers- 25
Horn- 15
Radio- 10
Parking Lights- 10
Ignition- 25
High Beams- 15
Wipers- 15
Starter Solenoid- 15
Fuel Pump- 25
From
Mastercell
Suggested Fuse Ratings
12V+ from
front
Megafuse to
any of 2 of
the 3 Power
Inputs
“B” Connector
“CAN”
Resistor
Plug
“B” Connector
12V+ from
rear
Megafuse
Function
Single Filament or Multifilament?
Single filament tail lights have a single
filament on one light bulb that is used for turn
signals and brake lights.
R
#2
#1
*Note: Values are suggested based on generic
requirements. Actual required fuse size may
differ from those listed. Base fuse selection off of
smallest wire gauge connected to the output.
Rule of Thumb: If your tail lights have
yellow on them, then they are multifilament.
If your tail lights are red ONLY, they are
single filament
Dash or Firewall
Mount
Trunk Mount
Power
Connector
Dummy
Plug
“A” Connector
Power
Connector
Dummy
Plug
“A” Connector
CAN Cable
Dummy
“CAN”
Cable
Connector
Black-To Chassis Ground
Black-To Chassis Ground
6007
Tan- OPEN or Fuel Pump
Yellow-Front Park Lights & Gauge Lighting
Orange-OPEN
High Beam Indicator
Blue-Headlight High Beam & Indicator
Green-OPEN
Wiring for Fans and Other Loads
with Current Draw Above 25 Amps
Green-OPEN
Blue-OPEN
+12V
Orange-Horn
POWERCELL
Output
Tan-Radiator Fan (Under 25 Amps)
ISIS Standard
To Fuel Pump
Inertia Switch may
require auxiliary relay
Fan or
load
greater
than 25 A
Chassis
Ground
Yellow-Rear Parking Lights
IMPORTANT!
Your Engine Management
System may require the
Fuel Pump and Inertia
Switch to be connected to
the ECM
Open
Open
Ignition*
Starter*
Headlights
Parking Lights
High Beams
Open
Horn
Fan Override or Open
Self-Canceling Left Turn Signal
Self-Canceling Right Turn Signal
4-Way Flasher with Self-Canceling Turn Signals
Brake Lights with Self-Canceling Turn Signals
HID Headlights
Open
Open
Open
Fuel Pump* or Open*
Open
Open
Open
Open
Open
Brake Lights with 1-Filament Bulbs
Right Turn Signal for 1-Filament Bulbs
Left Turn Signal for 1 Filament Bulbs
4-Way Flasher for 1-Filament Bulbs
Brake Lights with Multifilament Bulbs & Mechanical Column
Right Turn Signal for Multifilament Bulbs & Mechanical Column
Left Turn Signal for Multifilament Bulbs & Mechanical Column
4-Way Flasher for Multifilament Bulbs & Mechanical Column
Open
Open
Open
Open
Open
Alternating Headlight Toggle
Push Button Ignition/Start*
Alternating Headlight Toggle HID
* Security Aware
Switch
MASTERCELL
MASTERCELL
POWERCELL
POWERCELL
POWERCELL
Input
Connector
Wire Color
Address
Output
Connector
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
B
2
2
1
1
1
1:2
1
1
1
1
1:2
1:2
1:2
2
1
2
2
2
2
3
3
3
3
3
2
1:2
1:2
1:2
2
1:2
1:2
1:2
3
3
3
3
3
1
1
1
4
5
3
4
5
6:6
7
8
9
10
1:1
2:2
1&2:1&2
3
5
7
8
9
10
1
2
3
4
5
1&2
2:2
1:1
1&2:1&2
3
2:2
1:1
1&2:1&2
6
7
8
9
10
5:7
3:4
5:7
B
B
B
B
B
A
A
A
A
A
B
B
B
B
B
A
A
A
A
B
B
B
B
B
B
B
B
B
B
B
B
B
A
A
A
A
A
A:B
B
A:B
WHT-BLK
WHT-RED
WHT-BLU
WHT-YEL
WHT-GRN
BLU-BLK
BLU-RED
BLU-Lt BLU
BLU-YEL
BLU-GRN
YEL-BLK
YEL-RED
YEL-BLU
YEL-ORG
YEL-GRN
TAN-BLK
TAN-RED
TAN-BLU
TAN-YEL
TAN_GRN
GRN-BLK
GRN-BRN
GRN-BLU
GRN-ORG
PNK-BLK
PNK-RED
PNK-BLU
PNK-YEL
PNK-GRN
Lt BLU-BLK
Lt BLU-RED
Lt BLU-BRN
Lt BLU-YEL
Lt BLU-GRN
TAN-BLK
TAN-RED
TAN-BLU
TAN-ORG
TAN-GRN
BRN-BLK
POWERCELL Wire Color
Light-Blue
White
Light-Green
Light-Blue
White
Yellow:Yellow
Blue
Green
Orange
Tan
Brown
Violet
Brown:Violet
Light-Green
White
Blue
Green
Orange
Tan
Brown
Violet
Light-Green
Light-Blue
White
Brown&Violet
Violet:Violet
Brown:Brown
Brown&Violet:Brown&Violet
Light-Green
Violet:Violet
Brown:Brown
Brown&Violet:Brown&Violet
Yellow
Blue
Green
Orange
Tan
White:Blue
Light-Green:Light_Blue
White:Blue
Personality
Track
Track
Track
Track
Track: Soft-Start
Track
Track: Soft-Start
Track
Track
Track
Self-Canceling Turn Signals
Self-Canceling Turn Signals
4-Way Flashers
Track: Brake Function
Track
Track
Track
Track
Track
Track
Track
Track
Track
Track
Track: Brake Function
1-FilamentTurn Signals
1-FilamentTurn Signals
Track: Pattern
Track
Track Pattern: Turn Signal
Track Pattern: Turn Signal
Track: Pattern
Track
Track
Track
Track
Track
Alternating Headlight
NODE_EFI_START
Alternating Headlight