Problem statement for Seismech`15, IIT Guwahati

Problem statement for Seismech'15,
IIT Guwahati
Innovation Intelligence®
Copyright © 2012 Altair Engineering, Inc. Proprietary and Confidential. All rights reserved.
MotorCycle
Problem Definition & Inputs :








Import the Solid Model of Skateboard in SolidThinking Inspire 2014. (
Use the file motorcycle.igs)
Create make the red coloured component as Non Design and rest as
Design.
Create the Manufacturing Constrains as Extrusion.
Apply the force as show in the image below.
Apply the Constraints as shown in the image below.
Run the base line Analysis ( Linear Static Analysis)
Run the Optimization Analysis ( Topology Optimization) to reduce the
weight, but make sure the stress value should not increase by 30%. I.e.
if in base run your stress is 100 N/mm2. then after Optimization, the
optimized shape should not have stress more that 130 N/mm2.
Perform the Linear Static Analysis on Final Optimized shape.
Solution to be submitted :
250N
12600 N
2052 N
4710 N
15000 N
2016 N
18000 N




250 N In X and Y Axis
.stmod file before base line Analysis. i.e. that file should contain the
edited geometry.
.stmod file after base line Analysis. i.e that file should contain analysis
results, as stress and displacement values.
.stmod file after Optimization. i.e. that file should contain the
Optimization results.
.stmod file after linear static analysis. i.e. that file contain the stress and
displacement values..