JD440-CGRAPPLESKIDOER

Transcription

JD440-CGRAPPLESKIDOER
JD440-CGRAPPLE
SKIDOER
FEATURES
ENGINE PERFORMANCE
70 SAE net hp (71.0 PS)
220
Articulated frame power steering
r--
Oscillating front axle
210
TOROUE
~
200
w
is 100
g
~
6-speed Syncro-Range transmission
......
........
""'-
180
Z
170
Front-axle differential lock
" l'.
Wet-disk power brakes
360-degree rotation of grapple
160
70
55
HORSEPOWER
60
/'
"
~
~
~
55
1/
50
.45
.40
35
ffi
17,600 lb. (7983 kg) maximum
lifting capacity
"
~
6 ft. 3 in. (1.91 m) grapple opening
!
~
~
~
w
z
FUEL CONSUMPTION
~
1200
1400
1600
1800
2000
2200
ENGINE SPEED-RPM
16
I
L
JD440-C GRAPPLE SKIDDER SPECIFICATIONS
(Specifications and design subject to change without notice.
otherwise
noted, these specifications
Wherever applicable, specifications
are in accordance with ICED and SAE Standards. Except where
are based on a unit equipped with Syncro-Range transmission, 18.4-26, 10-ply logging tires and standard equipment)
Power (@ 2200 engine rpm):
Gross
Net
"""""""""""
""""""""""""
SAE
76hp (56.7kW*)
70hp(52.2kW)
71.0 PS
Net engine flywheel power is for an engine equipped with fan, air cleaner,
water pump, lubricating
oil pump, fuel pump, alternator and muffler. The
gross engine power is without fan. Flywheel power ratings are under SAE
standard conditions
of 500-ft. altitude and 85° F. temperature,
and DIN
70 020 conditions (non-corrected).
No derating is required up to 10,000 feet
(3000 m) altitude.
'In the international
system of units (SI) power is expressed in kilowatts
(kW).
Engine: John Deere 4-cylinder-diesel, 4-stroke cycle
Bore and stroke
.4.19x5.00 in. (106.4x127 mm)
Piston displacement. . . . . . . . . . . . . . . . .276 cu. in. (4523 cm3)
Compression ratio
16.7t01
Maximum torque @ 1200 rpm
220 Ib-ft (298 Nm)
(30.4 kg-m)
NACC or.AMA (U.S. Tax) horsepower
.28
Lubrication
.Pressure system w/full-flow filter
Cooling. . . . . . . . . Pressurized w Ithermostat and fixed bypass
Fan
Blower
Air cleaner wi restriction indicator. . . . . . . . . . . . . . . . . . . . . Dry
Electrical
Batteries
system.
. . . . . . . . . . . . . . . . . . . .12-volt wi alternator
(2) . . . . . . . . . . . . . . . . . Reserve capacity: 410 minutes
Differentials:
Front.. . . . . . . . . . . . . . . . . . . . Full
Rear
differential w/hydraulic lock
.Solid axle wino differential action
Transmission: Syncro-Range
Constant mesh with 6 speeds forward, 3 reverse. Three forward
speed ranges with synchronized shifting between low and high
within each range. Incorporates a brake lock for service
brakes. Clutch is 11 in. (280 mm), dry, feramic-faced, footpedal-operated.
Travel Speeds (2200 engine rpm, no tire slip):
Forward: 2 mph (3.2 km/h) to 15 mph (24.1 km/h)
Reverse: 2 mph (3.2 km/h) to 10 mph (16.1 km/h)
Brakes:
Hydraulic power actuated, wet-disk service brakes on output
shaft. Hand-operated mechanical brake for parking.
Drive Axles:
Four-wheel drive with inboard planetary gears on all axles.
Front axle oscillates 15 degrees above and below horizontal.
18 in. (457 mm) total travel at tire center line.
Power Steering:
Articulated frame hydraulically actuated by dual cylinders.
Turning radius
17ft.8in.(5.38m)
Turning clearance
... ... .37ft.1 in. (11.30m)
Hydraulic System:
Closed-center constant pressure. Variable-displacement pump
driven from crankshaft
.25 gpm (95I1min), 2000 psi
(137.9 bar) (140.6 kg/cm2) @ 2200 engine rpm. Full flow filtration. Oil to air cooler.
Hydraulic Cylinders:
Bore
Stroke
Lift (2)
4.0in.(102mm)
30in.(762mm)
Grapple (1) . . . . . . . . . . . . . . 5.25 in. (133 mm) 17 in. (432 mm)
Cylinder rods. .Ground, heat-treated, chrome-plated, polished
Lift cylinder rods
2-in.(51 mm)dia.
Grapple cylinder rod
.2.25 in. (57 mm) dia.
Tires:
18.4-26, 10-ply-rating, logging, LS2
16.9-30, 10-ply-rating, logging, LS2
Capacities:
Fueltank
Cooling system
Engine
,
U,S.
42gal.
8gal.
lubrication, including filter. . . . . . . . . .15 qt.
Transmission case (includes hydraulic system) 8 gal.
Front differential
4.5gal.
Reardifferential
4.5gal.
Winch
2.5gal.
Liters
159.0
30.3
14.2
30.3
17.0
17.0
9.5
Additional Standard Equipment:
Flanged axles
Ether starting aid
Muffler
Engine side shields
Fuel gauge
Deluxe seat w/suspension
Oil pressure gauge
Roll-over protective structure
Alternator charge
(RaPS) wi canopy, seat belt,
warning light.
brush screens, & limb risers
Water temperature gauge
Transistorized voltage
Lights
regulator
John Deere winch
Vandal protection
Front axle dilferentiallock
Altitude compensator
Electric hourmeter
Key switch w/push-button
safety start
Cigaret lighter
Horn
Fire extinguishers (2)
Foot throttle
Hand throttle
Front blade
Winch:
Live mechanical drive; hydraulically actuated clutch and brake.
Single-lever control.
Cable capacities*:
Y2-in. (12.7mm) cable
2301t.(70.1 m)
5/a-in. (15.8mm) cable
1511t.(46.0m)
3,4-in.(19.1 mm)cable
1071t.(32.6m)
'Calculated: No allowancemade for loose or uneven spooling.
Line pull (1600 rpm)*':
Bare drum. . . . . . . . . . . . . . . .22,200 lb. (99.5 kN) (10070 kg)
Full drum
13,700Ib.(61.4kN)(6214kg)
"Based on engine torque.
Line speed (2200 rpm):
Bare drum
Fulldrum
119fpm(36.3m/min)
194Ipm(59.1m/min)
Blade: Hydraulic control
Width
6ft.(1.83m)
Height (ends)
11t.8in.(508mm)
Height (center)
21t.3in.(686mm)
Max. lilt above ground level. . . . . . . . . . . . . . . . . . .4 It. (1.22m)
Max. drop below
ground
level.
. . . . . . . . . . . . .9.5 in. (241 mm)
SAE Operating
Weight.
. . . . . . . . . . . . . . . .16,525
lb. (7496 kg)
Special Equipment:
Wheel weights
Steering accumulator
Engine coolant heater
Cab with heater and noise treatment
Windshield with wiper
3 in. (76 mm) seat belt
Log arch with adjustable rollers
17
JD440-C GRAPPLE SKIDDER DIMENSIONS
Sideview dimensions are for Skidder equipped with 18.4-26 tires, grapple open.
r
9 ft. 4 in.
(2.84 m)
~;::::-<~~:::
II
1
':, ~-' I
u":i.-~
::'..~.~.
"",;:,g;;
;,,1',
lHHiii!!
.q~-"
II"
.E
::;""-~I It~
" "II
=C\J
:: A! II
v"!....
:~~:: :::::::::"
'-'..\
'1'--"
-'"/'
--- '-, ;::",-,/.--f
-~.I I
i:" 111111
:11::
"
111""
iii,i:::
",,""
""::i;
-'~~"--
::1:1 ::.J:
2 ft. 7 in.
(788 mm) ::::::
-1-::iJ
1
i;
"'~:'--~
iW
6ft. 11in. (2.11m)-I-
9.5 in.
(241 mm)
106in. (2.69m)
19 ft. 11 in. (6.07 m)
"
---
"--'-
"
--,
-- "
\\\
\J
,
I
I
I
..lL'
.f'
B
5 in, (127 mm)
A
G
TIRE
SIZE
A
WHEEL TREAD
6 ft. 3 in. (1.91 m)--j
B
GROUND
CLEARANCE
C
OVERALL
WIDTH
16.9-30
74 in.
(1.88 m)
1 ft. 7 in.
(483 rom)
7 ft. 7 in.
(2.31 m)
18.4-26
74 in.
(1.88 m)
1 ft. 6 in.
(457 rom)
7 It. 8.4 in.
(2.35 m)
18
t

Similar documents

jd440-c skidder

jd440-c skidder Transmission case (includes hydraulic system) 8 gal. Front differential """""""""""'" 9gal.

More information

440B tractor

440B tractor Front axle oscillates 15 degrees above and below horizontal. 18 in. (457 rom) total travel at tire center line. Power Steering: Articulated frame hydraulically actuated by dual cylinders. Turning r...

More information

644B - John Deere

644B - John Deere gross engine power is without fan. Flywheei power ratings are under SAE standard conditions of 500-ft. aititude and 85°F. temperature and DiN 70020 conditions (non-corrected). No derating is requir...

More information

JD440-BSKIDDER

JD440-BSKIDDER driven from crankshaft. . . .28 gpm (106 Ipm), 2.000 psi (140,6 kg/cm2) @ 2,500 engine rpm.

More information

440d skidder

440d skidder 276cu.in.(4.524L) Maximum net torque @ 1300 rpm . . . 253 Ib-ft (343 Nm) (35 kg-m) Cooling fan Blower Compressionratio 16.8t01 Lubrication. . . . . . . . . . . . . . . . . Pressure system w/full-fl...

More information

JD440SERIES-ASKIDOER

JD440SERIES-ASKIDOER Suction fan Hydraulic system Engine side-shields Power steering Power brake Air cleaner (dry type) Muffler 140-amp. hour battery installation (two 70 amp. batteries) Fuel gauge Canopy Oil-pressure ...

More information