The Bouglé - AuSable River Two Fly Shop

Transcription

The Bouglé - AuSable River Two Fly Shop
The Bouglé
BOUGLÉ FLY REEL
The first Hardy Bouglé reel was catalogued in 1903, and was, as it
remains to this day, a variation on the famous Hardy Perfect reel.
The variation was initially requested by Frenchman Louis Bouglé,
an extremely knowledgeable fisherman and tournament caster who
requested that Hardy produce a reel with a good line capacity which
remained light enough to balance rods between 41/2oz and 8oz.
From this initial request, the Bouglé reel went from strength to
strength and became one of the most famous reels in angling history.
Now, 110 years later, we at Hardy Bros., Alnwick are proud to offer
a new variant of the Bouglé reel which we feel is one of the best
yet—with its rolling pillar; reversible click check; naval brass bush
and spindle; and its hand polished, deep anodised ‘pearl silver’
finish. This Bouglé reel is sure to become one of the classics.
Made by time served Hardy Bros. reel makers here in Alnwick,
England, this Bouglé reel comes presented in a beautiful,
UK made, soft leather, sheepskin lined reel case.
CARE & MAINTENANCE
1. Remove line and backing.
2. Remove the spool.
3. Flush away dirt by placing the spool and
frame under a stream of fresh water.
4. Dry carefully with a lint free cloth.
5. Lubricate with a good quality oil at the
points illustrated on the diagrams.
6. Always ensure the spindle
is adequately greased.
7. Always turn the click-check to
the minimum setting to avoid
compression of the springs.
8. Always ensure the reel and line are dry
before storing in the case or pouch.
Grea
Grea
Oil
Grease
Oil
Grease
Grease
Revolving Pillar
Grease
Revolving Pillar
REVOLVING PILLAR MAINTENANCE
Pillar Screw PILLAR MAINTENANCE
REVOLVING
Pillar
Grease
Pillar Screw
Grease
Pillar
At least once per season, remove
the pillar screw using a good fitting
screwdriver. Using a good quality
At least
once per
season,
removethe
water
repellant
grease,
lubricate
the pillar
screw
using
good fitting
shaft
of the
screw
anda replace.
screwdriver.
Using
a
good
Wipe off any excess with aquality
cloth.
water repellant grease, lubricate the
shaft of the screw and replace.
Wipe off any excess with a cloth.
REMOVING THE SPOOL
Spool dismantling procedure
1. Remove the locking screw using a good
fitting coin or screwdriver, turn locking
screw clockwise to remove.
2. Rest the palm of your hand against the face of
the spool, turn winding plate anti-clockwise to
remove from spool. The spool, winding plate and
frame should all be seperated at this point.
To re-assemble the spool please reverse
the above dismantling procedure.
Frame
Wind Plate
Grease
Spool
BOUGLÉ CLICK-CHECK MECHANISM
The click-check mechanism can be adjusted by simply turning the regulator
wire on the side of the frame, anti-clockwise to increase the check, clockwise
to decrease the check. When the reel is not in use, the check should be turned
to the minimum setting (not applicable to the Bouglé Baby model).
Regulator Wire
REVOLVING PILLAR MAINTENANCE
Pillar Screw
rease
Revolving Pillar
e per season, remove
ew using a good fitting
Using a good quality
nt grease, lubricate the
screw and replace.
excess with a cloth.
Pillar
At least once per season, remove
the pillar screw using a good fitting
screwdriver. Using a good quality
water repellant grease, lubricate the
shaft of the screw and replace.
Wipe off any excess with a cloth.
LEFT TO RIGHT WIND CONVERSION
All Bouglé reels are designed to work in right or left hand wind.
When you receive your reel, it will be set for left hand wind.
1. Remove the plate and spool out of the
frame by following the spool dismantling
procedure described previously.
Stop Screw
(4” model only)
Left Hand
Tongue
2. Pick up the frame so that the
mechanism is visible.
3. Remove stop screw and collar from
above LH tongue (4” model only).
Right
Hand Tongue
4. Using your thumb and forefinger, switch
the left hand tongue into the off position.
5. Using your thumb and forefinger,
switch the right hand tongue
into the engaged position.
Stop Screw
(4” model only)
6. Replace stop screw and collar above
RH tongue (4” model only).
7. Replace the plate and spool on
to the frame – your reel should
now be right hand wind.
This frame is shown in
Left Hand Mode
This frame is shown in
Left Hand Mode
Left Hand
Tongue
Right
Hand Tongue
This frame is shown in
Right Hand Mode
This frame is
Right Han
SPECIFICATION
Code
Reel
Extreme Diameter
(inches)
Weight
(g)
Capacity
(m)
HEB010
Baby Bouglé Reel
213/16
90g
DT2+25m
HEB020
3" Bouglé Reel
3
102g
DT2+70m
HEB030
31/4" Bouglé Reel
31/4
116g
DT4+100m
HEB040
31/2" Bouglé Reel
31/2
133g
DT6+70m
HEB050
4" Bouglé Reel
4
225g
DT10+225m
Code
Spool
HSB010
Baby Bouglé Spool
HSB020
3" Bouglé Spool
HSB030
31/4" Bouglé Spool
HSB040
31/2" Bouglé Spool
HSB050
4" Bouglé Spool
WARRANTY
All Hardy Bros. Bouglé reels carry a lifetime original owner warranty
against any defect in workmanship or materials. Should there be any
defect, Hardy will, at its discretion, repair or replace the item. This
warranty does not cover damage caused by misuse, lack of maintenance,
negligence or normal wear and tear. Warranty claims with the proof of
purchase should be sent FAO Customer Services Department to:
Hardy & Greys Limited
Willowburn, Alnwick
Northumberland
NE66 2PF
England
Hardy North America
1260 Corporate Boulevard
West Hempfield Township
Lancaster, PA 17601
United States of America
Hardy & Greys GmbH
Brägeler Forst 7
D-49393 Lohne
(Oldenburg)
Germany
Tel: +44 (0)1665 602771
Fax: +44 (0)1665 602389
Tel: +1 (717) 537 3900
Fax: +1 (717) 537 3905
Tel: +49 (0) 44 42–80 29 20
Fax: +49 (0) 44 42–80 29 229
www.hardyfishing.com
[email protected]
www.hardyfishing.com
[email protected]
www.hardygreys.de
[email protected]
Fine fishing tackle since 1872
Hardy & Greys Limited
Willowburn, Alnwick, Northumberland NE66 2PF England
Tel: +44 (0)1665 602771 www.hardyfishing.com