Finisher-Instructions

sabino
888.305.4247 • www.sabinohair.com
Finisher
Finisher’s waterproofing properties make it excellent in any climate for any of the following uses.
As a Hair Spray
1. Hold Finisher about 8 inches from the area of your hair where you desire hold and press
the pump hard, using a sweeping motion while spraying. This will give you even coverage.
2. Add more layers of coverage as you desire.
3. If you want to adjust you hair later, do not add more Finisher but instead mist your hair with
a little water and adjust. No more finisher is required.
As a Curl Definer
1. Apply Lök & Blök or Moisture Block on wet hair as directed. Apply more than normal.
(For example, if you normally use a US quarter size, apply another ½ quarter size. Start
at ends and work up to roots.)
2. Spray Finisher over Lök & Blök or Moisture Block when hair is wet. Brush both products
through for even distribution.
3. Either twist or don’t twist hair and diffuse or let dry naturally; your choice.
4. As hair starts to dry, you may see some halo frizz starting. Spray a little more Finisher and
continue to dry but do not brush.
5. When hair is 85% dry, add a little more Lök & Blök or Moisture Block by gently raking it
through the hair. If you twist your hair, you can either gently separate or leave until dried.
As a Volumizer
1. Apply Lök & Blök or Moisture Block as directed for either flat ironing or wearing hair
naturally curly.
2. When your hair is completely styled and finished, lift your hair from the roots at the crown
or wherever you desire volume.
3. Hold Finisher about 2 inches from the roots and spray.
4. When you have applied to all of the areas, place your blower on high heat/low air and
lift the hair from the roots.
5. Point the blower into the areas for about 3 seconds at the roots where you sprayed Finisher.
Pull the blower away and continue holding your hair in the same position for a count of 10.
6. Move to the next section and repeat until all of your hair is standing up from the scalp.
7. Hand-scrub your roots to break up the hair.
8. Lightly brush into place.
9. Place the brush at the same areas, holding it away from the scalp into position.
10. Spray with Finisher in each section. Lightly adjust and that’s it!