X2525P Xylophone Assembly

Marching Xylophone
Assembly Instructions for X2525P
1
Check Contents
1. Tone Bars (naturals & accidentals)
2. Keyboard Frame
3. Mounting bracket & Carrier (optional)
4. Resonator Set (optional)
5. X-stand (optional)
x 2 st
x 1 pc
x 1 st
x 2 pc
x 1 st
4
3
2
1
2
3
For more information please visit
http://www.majestic-percussion.com
Ver.201212
4
Stand and frame Assembly
Setup the X-stand by releasing the pressure pin in the middle plate, set to
preferred height and return the pin to position for safety. Connect keyboard frame
with X-stand (optional) by inserting the center crossbar into the U-bracket holders.
5
Attach bars to the frame
1. Unroll the tone bars carefully, holding the cord from both ends, place the bars
onto frame.
5
3
Resonator Assembly
Resonator (optional) insert pins at low register end of the frame, align the connecting
screw with connector on upper register at rail, tighten knob to secure.
Mounting bracket Assembly
Connect keyboard frame with Mounting Bracket by inserting the center crossbar into
the U-bracket holders.
2. Align bars between each post, slide cord into the ring of each post. (Attach the
naturals first, followed by the accidentals)
3. Pull the cord at the low register end to a medium tension. And then connect the
springs. (adjust the knot at each spring to adjust tension)