Kingsley-Bate

Kingsley-Bate
TR122 Essex 122" Oval Extending Dining Table
Assembly Instructions
KINGSLEY - BATE
Fine Garden Furniture
0
ASSEMBLY INSTRUCTIONS FOR THE TR - 122
TABLE TOP ASSEMBLY
2
FOLDING LEG ASSEMBLY
EXTENSION TOPS
LOCKING PIN
LOCATING PIN
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture pleas e match the tenons and m ortise holes with
the corresponding letters or numbers stamped on the furniture.
* NOTE
A TENON
B MORTISE HOLE
STEP-II
Fit the num bered tenons of the LEGS into th e respective m ortise holes of the BASES.
With a rubber mallet hammer in the LEGS until all the joints fit snugly together.
STEP-III
Carefully hammer dowels into respective holes as shown in the assembly
photos. To avoid m arring of wood, we suggest that you place a block of
wood between the dowels and the ham mer for the last few blows. If the
dowels are not com pletely flush, us e the sandpaper provided to rem ove
the excess. *DO NOT FORCE DOWELS*.
STEP-IV:
Fit the num bered tenons of the LEG
STRETCHERS into the respective m ortise
holes of the LEG/BASE ASSEMBLY.
Place
the remaining LEG/BASE
ASSEMBLY mortise holes onto and over
the tenons of the LEG STRETCHER. With
a rubber mallet, hammer the wood until all
the joints fit snugly together.
STEP-V:
Insert the dowels to the joints as shown in assem bly photo. Again,
please be careful not to mar the wood and do not force the dowels. Any
excess can easily be sanded away.
STEP-VI
Place the TABLE TOP asse mbly up side down and
carefully match the letters or numbers of the LEGS with
the respective letters or num bers of the TABLE TOP
frame as shown in photographs.
STEP-VII
Insert the knock down bolts through the joints and slide the washers
and locking washers over the threads and secure with the nuts.
Tighten all the nuts with provided (10mm) wrench.
STEP-VIII
Upright the table and pull out the sliding rail under
the table ends. Attach
the two halves of the
EXTENSION TOPS to either side of the TABLE
TOP. Carefully attach the LOCATING PIN (male)
of the EXTENSION TOP and LOCATING PIN
(female) of the TABLE TOP as shown in assem bly
photographs. Pull the LOCKING PIN under the EXTENSION TOP and adjust the sliding
rail to fit with the LOCKING PIN.
**We recommend that two people upright the table. ***
STEP-IX
The two half round extensions can convert
halves up side down, push them together.
into a separate round table. Place the two
STEP-X
Place the FOLDING LEG ASSEMBLY on the locking bracket and
lock the stand into place with the LOCKING PINS.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
1
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY *
7200 Gateway Court, Manassas, Virginia 20109
Phone: 703-361-7000, Fax: 703-361-7001