48 STEP PER DEGREE RETRANSMISSION UNIT

Transcription

48 STEP PER DEGREE RETRANSMISSION UNIT
KW948
48 STEP PER DEGREE RETRANSMISSION UNIT
The KW948 interface converts serial heading data from
a modern gyro to a 48 step per degree signal.
Applications include refitting a ship with a new gyro, whilst
retaining the existing repeaters. Applicable gyro types are the
old C Plath and Anschutz gyros.
Typical repeaters take no more than 0.8 amps per step. The
KW948 provides high voltage to rotate the repeaters, and then
it gives a low (rms) voltage to hold position at a low current.
HEADING INPUTS
All valid NMEA 0183 heading sentences, which most modern
gyros give as standard and GPS heading sensors etc.
World Leaders
in Marine Interfacing
and Retransmission
Solutions
AMI Marine (UK) Ltd
Unit 2 Tower Industrial Estate,
Tower Lane, Eastleigh, Southampton,
Hampshire, UK SO50 6NZ
Tel: +44 (0) 2380 480450
[email protected]
[email protected]
www.amimarine.net
KW948
SPECIFICATION
INPUT:
NMEA 0183. All valid heading sentences. 4800 baud.
One or two decimal places (or more) are accepted.
OUTPUT:
Drive for 2 pole stepper motors. Maximum current 8 Amps total.
24 volts DC for illumination. 6 pin connector.
Rotation (follow-up) rate. 5 or 10 degrees per second.
Adjustable by jumper.
ALARM RELAY:
Low power single pole change over relay to switch an independent
external audible and visual alarm. (not supplied)
POWER:
CONNECTIONS: 24 volts DC at 0.2 to 6 Amps depending on load.
Auto reset fuse on removal of power.
ENCLOSURE:
APPROVALS: World Leaders
in Marine Interfacing
and Retransmission
Solutions
Pluggable terminal blocks.
Electrical enclosure with door.
300 x 250 x 155 mm.
Complies with IEC60945
AMI Marine (UK) Ltd
Unit 2 Tower Industrial Estate,
Tower Lane, Eastleigh, Southampton,
Hampshire, UK SO50 6NZ
Tel: +44 (0) 2380 480450
[email protected]
[email protected]
www.amimarine.net