Proe Afterburning(tm) Technology Brochure (Adobe pdf file)

Transcription

PPS 250 Solid Biofuel Powerplant
Technical Overview
Page 1
Proe
Power
Systems
Afterburning Ericsson Cycle Engine, Proe 90™ Recuperator,
and Proe Afterburning™ Cycle Engine are protected by
US Patents Number: 5,894,729; 6,390,185, 6,672,063, 7,028,476
and other pending
Seed to Circuit: Direct
Combustion of Solid
Biofuel for Electric
Power Generation
For Additional Information Contact Richard Proeschel
at (800)315-0084 (in USA) or 1-(330)723-4469 (International)
[email protected]
Proe
Power
Systems
Proe Power Systems, LLC
Why Biofuel Energy?
As the world makes important
commitments to a future powered with
clean renewable energy, solutions utilizing
BIOFUEL will play an increasingly
important role.
Bio energy is energy derived from
harnessing the power within biofuel.
For the PPS 250, biofuel is a wide variety of
organic matter such as wood chips. The
PPS 250 can use these fuels with minimal
preparation other than chipping or
shredding.
Often lost in the conversation about
renewable energy, biofuel combined
with modern thermodynamic
technology, represents a renewable
resource that brings diversity to our
energy mix and a can play a critical role
in transitioning to a clean energy future.
Page 2
and other pending
[email protected]
Proe
Power
Systems
Finally – Realistic, Practical Renewable Energy:
The PPS 250 Solid Biofuel Powerplant
• 280 kWe Electric (Sized for ~200 Homes or 180,000 Sq Ft of Commercial Space)
+ 2000 gph hot water or 36 Tons of Cooling + 1275 gph hot water
• Based on low cost Automotive, not Exotic Gas Turbine Hardware
• Simple, Historically Proven, Engine Construction; Remainder of Equipment is
Commercially Available
•Standardized Modular/Turnkey Installation: Simplifies Siting, Permitting &
Repositioning to Meet Community Needs
• Produce Power at 21/2 to 71/2¢ per kWe-hr Fully Loaded without Government Subsidy
• Ideal for a Wide Range of Renewable Alternative fuels:
Wood Chips, Bamboo, Refuse Derived Fuel (RFD), Livestock Manures, Miscanthus,
etc. (Pelletization not needed)
• Provides clean efficient means for Direct Combustion
of Carbon Neutral Solid Fuels and Cellulosic Biomass (without the need for a gasifier
or digester)
Page 3
and other pending
[email protected]
Proe
Power
Systems
The PPS 250 Powerplant is A Standardized Product
Delivered on 4 Truck Size Pallets (40’ x 60’ footprint)
Proe
Power
Systems
Page 4
and other pending
Seed to Circuit: Direct
Combustion of Solid
Biofuel for Electric
Power Generation
[email protected]
Proe
Power
Systems
The PPS 250 Powerplant is A Standardized Product
Delivered on 4 Truck Size Pallets (40’ x 60’ footprint)
Combined Rotating Unit
Compressor/Expander/Generator/Controls
Ash
Bin
Combustor & Air Heater
Fuel Dryer, CHP Water Heater &
Fly Ash Cyclone
Fuel Bin & Loading Hopper
Page 5
and other pending
[email protected]
Proe
Power
Systems
PPS 250 Solid
Biofuel Powerplant
37 ft
Cyclone Fly
Ash Trap
Air or Flue Gas
Connector
(4 Places)
Fuel
Loading
Hopper
Fuel
Dryer
and
Optional
Water
Heater
57 ft
Combustor
and Air
Heater
Fuel
Storage Bin
Combined Rotating Unit
• Compressor
• Expander
• Synchronous Generator
• Controls
• Electric Interface
Page 6
Fuel
Transfer
Augers
Ash
Transfer
Auger
“Roll Off”
Dumpster
for Ash
Disposal
and other pending
[email protected]
Proe
Power
Systems
HOW IT WORKS
The PPS 250 Solid Biofuel
Powerplant has the Proe
Afterburningtm engine at its heart.
This engine is based on technology
that has been used commercially
for over a century but brought
into the 21st century with state-ofthe art engineering.
Solid Fuel
Combustor
515oF
Air Heater
Fuel Hopper
1550oF
3
1408oF
Ash Bin
Expander
4
2
318oF
888oF
Compressor
The engine is unique in that only
68oF
1
clean air passes through the
engine. Combined
1->2 Air is Compressed
with the engine’s
2->3 Heat is Added to Compressed Air
simplicity, the result
3->4 Heated Compressed Air is Expanded to Produce Work
is a rugged engine,
4 Hot Exhaust Provides Pre-Heated Blast Air to Combustor
ideally suited to solid
View Animated Versions at:
fuel combustion, having low
http://www.proepowersystems.com/How_It_Works.ppsx
and http://www.proepowersystems.com/Engine.htm
maintenance costs and low initial
capital cost.
Proe
Page 7
and other pending
[email protected]
Power
Systems
Fuel Agnostic: Economical Production of Electric Power
from A Wide Range of Renewable Fuels
10 Yr Electric Cost Using PPS 250 Solid Biofuel Powerplant
---Average Utility Grid Cost is ~$0.10 ---
Algae
Arundo
Bamboo
Cattle Manure
Fuel Source
Coconut Shells
Corn Husks/Stalks
Hog Manure
Horse Manure
Max
Lignite
Min
Miscanthus
Poultry Litter
RDF
Scrap Wood
Shredded Paper
Switch Grass
Wood Chips
0.00
0.01
0.02
0.03
0.04
0.05
0.06
0.07
0.08
0.09
Customer Value
Proe Power Systems powerplants can
produce electricity cost-competitively
with the added benefit of not requiring
the tremendous capital expense
required for large scale plants and long
transmission lines. Our powerplants can
be placed near users and thus deliver
power with minimal transmission loss.
The PPS 250 has direct combustion that
eliminates the energy losses, cost and
complexity of intermediate processes
involving digestion, gasification,
liquefaction, or steam generation. It
also allows a wide range of fuels that
can deliver electricity for less than 21/2
to 71/2 US¢/kW-hr; fully loaded and
without subsidy. This makes the PPS 250
a more than competitive alternative to
other renewable energy sources and
even with conventional power produced
by coal solutions.
($/kW-hr)
Page 8
and other pending
[email protected]
Proe
Power
Systems
Breaking the Cost
Barrier
Unless subsidized,
conventional
“renewable energy”
based on wind and
solar results in
electric power cost
exceeding the
average cost of the
utility grid. We
break that cost
barrier
Page 9
and other pending
[email protected]
Proe
Power
Systems
Proe Afterburning™ Cycle:
First Cousin to Turbojet Engines
Expander
Compressor
Combustor
Expander
Compressor
4
Shaft
1
3
4
2
Air
Inlet
Fuel
Inlet
Page 10
1
3
Combustor
2
1-2 Air is Compressed
2-3 Heat is Added to Compressed Air
3-4 Heated Compressed Air is Expanded to Produce Work
and other pending
[email protected]
Proe
Power
Systems
Legend
Proe Afterburning™ Cycle
Functional Block Diagram
Low Pressure Air
High Pressure Air
Fuel
AFTERBURNER
Combustion Products
Heat Transfer
FUEL
CONTROL
VALVE
Mechanical Work
Air Heater
FUEL
IN
5
4
EXHAUST
COMPRESSOR
AIR IN
EXPANDER
1
3
2
HEAT
OUT
WORK
IN
WORK
OUT
Just like a Jet:
1-2 Air is Compressed
2-3 Heat is Added to Compressed Air
3-4 Heated Compressed Air is Expanded to Produce Work
Page 11
and other pending
[email protected]
Proe
Power
Systems
Proe Afterburning™ Engine Provides Simple and
Efficient Power Generation from Solid Fuels
Page 12
and other pending
[email protected]
Proe
Power
Systems
Proe Afterburning™ Cycle: Lowest Cost of Electric Power
Generation Using Second Generation Solid Biofuel
Cost of Generation Compares:
Switchgrass or Wood Chip Fueled:
- Proe AfterburningTM
- Stirling
- Steam
- Gasifier\Reciprocating Engine
- Brayton Turbine
(AgriPower and Talbott’s)
Solar, Wind, Diesel Generator, and
Natural Gas Fuel Cell are shown
for Reference
Cost of Generation Includes:
- Initial Cost
- Maintenance & Operator Cost
- Availability
- Fuel Cost
Costs Do Not Account
For Savings from:
• Govt Subsidies or Incentives
• Heating Cost Avoidance
• Cost Recovery from Ash Sales
Page 13
and other pending
[email protected]
Proe
Power
Systems
Proe Afterburning™ Cycle: Lowest Cost of Electric Power
Generation Using Solid Waste Cellulose (i.e. Citrus Processing)
Cost of Generation Compares:
Waste Wood or Refuse Fueled:
- Proe AfterburningTM
- Stirling
- Steam
- Gasifier\Reciprocating Engine
- Brayton Turbine
(AgriPower and Talbott’s)
Solar, Wind, Diesel Generator, and
Natural Gas Fuel Cell are shown
for Reference
Cost of Generation Includes:
- Initial Cost
- Maintenance & Operator Cost
- Availability
- Fuel Cost
Costs Do Not Account
For Savings from:
• Govt Subsidies or Incentives
• Heating Cost Avoidance
• Cost Recovery from Ash Sales
Page 14
and other pending
[email protected]
Proe
Power
Systems
Proe Afterburningtm Engine Technology is Totally New
A New Engine Cy cle
Page 15
and other pending
[email protected]
Proe
Power
Systems
Professionally Developed Technology has Received
Professional Peer Review
Page 16
and other pending
[email protected]
Proe
Power
Systems
Who We Are
Richard Proeschel, P.E., Chairman and Program Manager
• Registered Professional Engineer (#PE.71779) in Ohio
• Founder & Chairman of Proe Power Systems, LLC
• Retired from Boeing/Rockwell after 32 Years as a “Rocket Scientist”
• Associate Program Manager for International Space Station Electric Power System
• Test Supervisor for Space Shuttle Fuel Cell and Auxiliary Power Systems
• Worked “Mission Evaluation Room” in NASA Houston for Shuttle Development Flights
• Extensive Experience in Computer Modeling of Thermodynamic Systems
• Holds 4 Issued and 4 Pending U.S. Patents
• Author of Many Papers in Heat Transfer, Thermodynamics, Rocket Propulsion and Power
• BS in Fluid, Thermal & Aerospace Engineering from Case School of Engineering, Case Western
Reserve University
• MS in Systems Management (Management of High Technology Programs & Projects) from Viterbi
School of Engineering, USC
• Member of AEE, ASME, National & Ohio Societies of Professional Engineers, Ohio Academy of
Sciences, SAE
R. Michael Ujcich, Chief Investment Officer
• Environmental Entrepreneur for 24+ Years
• Commercial Project Site Design and Development With Emphasis on Renewable Energy
technologies and Green, Energy Efficient Construction Methods
• Green Energy Ohio Volunteer since 1986
• Renewable Energy Volunteer Consultant with University of Managua in Nicaragua
• B.S B.A. in Marketing from John Carroll University
Page 17
and other pending
[email protected]
Proe
Power
Systems
Proe
Power
Systems
”Making Thermodynamics a Household Word”
®
Developing Innovative New Technologies for
Energy Independence and Environmental Responsibility
Contacts:
Richard Proeschel, PE
Chairman & Program Manager
800-315-0084 x600
[email protected]
Michael Ujcich
Chief Investment Officer
800-315-0084 x500
[email protected]
www.proepowersystems.com
Page 18
and other pending
[email protected]
Proe
Power
Systems

Proe Afterburning(tm) Technology Brochure (Adobe pdf file)

Transcription

Similar documents

here - Felix Wong

Dual Port, Four Barrel, Aluminium lnlet Manifold. Crane Cam and

MOTORUP XTREME 800 Engine Treatment PDF

24` 5” Stratos 1993 $4500 - Chapman School of Seamanship

GE-S4200 - Sport - TMC Industries, Inc.

50` 3” Cheoy Lee 1984 - Chapman School of Seamanship

Sea Ray Overnighter 220

Spec Sheet for Campion Allante 705i

G8.3 And GTA8.3. - Cummins Engines

Blue 1990 Chevy Camaro IROC Z, single owner, 9,315 original