20060947 ATMOSPHERE IS GEN
Transcription
20060947 ATMOSPHERE IS GEN
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed, product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly. Ensure product is turned off, then use a screw driver to remove all screws. Separate product body halves to expose internal electronics. When battery is visible in its entirety use scissors to cut a single battery wire, immediately wrap the Charger Status OFF LED Blinking Green LED Solid Red ON/Charge (ATMOSPHERE™ not connected) Batteries Low (ATMOSPHERE™ not connected) Charging ATMOSPHERE™ cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of the product. Dispose of battery in accordance with your local battery recycling or disposal laws. NOTE: Opening of product and/or removal of battery will render product inoperative and voids manufacturer warranties, dispose of remaining product components in accordance with local laws. Charging ATMOSPHERE™ Complete Charge Error (LED Alternating) ATMOSPHERE™ Status OFF ON 8+ YRS TM Key Features ON + Low LiPo Battery ATMOSPHERE™ (indoor flyer): - Auto hovering sphere - Control with the palm of your hand. - Hand held charging cradle. a FCC Statement: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no a WARNING: CHOKING HAZARD – Small parts. Not for Children under 3 years. CAUTION: DO NOT FLY OUTDOORS Do not return to the store. If you are having difficulty operating your new Air Hogs®, call us toll-free at: 1-800-622-8339. or email us at: [email protected] guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user’s authority to operate the equipment. Contains 1 x 3.7 V 110mAh LiPo battery pack. Requires 6 x 1.5 V AA (LR6) alkaline batteries (not included). Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life it should not be disposed of with other household waste. The Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council. INSTRUCTION GUIDE NOTE: Always use fresh, premium quality batteries. CONTENTS LIST AND PARTS IDENTIFICATION x1 Battery requirement for ATMOSPHERE™: Power Supply: Rating: DC 3.7 V, 110mAh Requires 1 x 3.7 V LiPo Rechargeable Battery Pack (included) Battery requirement for charger: Power Supply: Rating: DC 9 V, 0.45 W Batteries: 6 x 1.5 V AA/LR6/AM3 Requires 6 x 1.5 V AA size batteries (not included) x1 x1 AIRHOGS.COM Stabilizer Rotor Fan Blades Power Light OFF/ON Switch a WARNING: IF ROTOR(S) BECOME DAMAGED OR BROKEN, DO NOT FLY. FLYING WITH BROKEN ROTOR(S) MAY CAUSE DAMAGE OR LEAD TO INJURY. Charge Port CHARGER SPIN MASTER LTD., 450 FRONT STREET WEST, TORONTO, ON M5V 1B6 CANADA Customer Care: 1-800-622-8339 Email: [email protected] Imported into EU by: SPIN MASTER INTERNATIONAL, S.A.R.L., 16 AVENUE PASTEUR, L-2310, LUXEMBOURG www.spinmaster.com TM & © Spin Master Ltd. All rights reserved. Please retain this information for future reference. Please remove all packaging materials before giving to children. An adult should periodically check this toy to ensure no damage or hazards exist, if so, remove from use. Children should be supervised during play. Keep addresses and phone numbers for future reference. The item inside this package may vary from the photographs and/or illustrations. Spin Master reserves the right to discontinue use of the www.airhogs.com website at any time. MADE IN CHINA. 20060947, 20062357, 20062358 REV 0 T44475_0001_20060947_GEN_IS_R1 a Warning: CHOKING HAZARD – Small Parts. Charge Plug Charge Light OFF ON/CHG Switch LED Transmitter Stop Button TM 4 1 HOW TO INSTALL BATTERIES TROUBLESHOOTING PROBLEM A ATMOSPHERE™ Charge Port Alignment B C CAUSE Charger LED is OFF but switch is in ON/Charge position. 1. Charger may be in sleep mode (enters sleep mode after about 2 minutes of inactivity). 1. Turn charger OFF then ON again. Stop button is not working. 1. ATMOSPHERE™ is out of range. 2. Charger is in sleep mode. 1. Move charger closer to the ATMOSPHERE™. 2. Turn charger OFF then ON again or press stop button again. Charger LED is flashing Red/Green alternatively while charging ATMOSPHERE™. Error while charging. Check that the connection between the charger and the ATMOSPHERE™ is not broken, if it is, reconnect it, turn charger OFF and then ON again. Charger LED is flashing Red. Batteries in charger are low. Install new batteries in charger. ATMOSPHERE™ will not start or has lost power. 1. You have not set the motor switch to “ON”. 2. Charger battery power is low. 3. Batteries (+) or (-) are not correctly placed inside the battery compartment. 4. ATMOSPHERE™ battery is low. 1. Slide motor switch to “ON”. 2. Replace the charger batteries. 3. Be sure to align the (+) and (-) polarities with the corresponding markings inside the battery compartment. 4. Recharge ATMOSPHERE™. ATMOSPHERE™ is flying too low. 1. The batteries in the charger are drained. 2. ATMOSPHERE™’s battery is low. 3. Hair or debris may be caught in the rotor. 1. Install new batteries in charger. 2. Recharge ATMOSPHERE™. 3. Remove hair or debris. ATMOSPHERE™ does not return to ground when I push the Stop Button. 1. Controller is not being pointed at ATMOSPHERE™. 2. Charger battery power is low. 1. Point the controller with the IR LED directly at the ATMOSPHERE™. 2. Install new batteries in charger. HOW TO CHARGE YOUR ATMOSPHERE™ 1. Switch ATMOSPHERE™ OFF. 2. Switch charger to ON/OFF . 3. Align charge port of ATMOSPHERE™ (A) with charge port 1 alignment guide (B) on charger then lower ATMOSPHERE™ onto charger carefully. 4. Switch ATMOSPHERE™ ON. 5. Switch charger to ON/CHG. 2 6. RED charging LED will light up. When charging is complete, the charging LED will turn from RED to GREEN. Things to remember: Before you recharge the battery, wait 10-15 minutes to let the battery cool down. A B NOTE: If normal function of the product is disturbed or interrupted, strong electro-magnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, 3 4 HOW TO USE YOUR ATMOSPHERE™ 1. Turn the Charger ON. 2. Ensuring your fingers cannot be hit by the rotors or stabilizer, turn your ATMOSPHERE™ ON. When you let go of the ATMOSPHERE™, it will slowly lift and start to fly. 3. Play with the ATMOSPHERE™ by putting your hand underneath it and watching it rise up. 4. When finished playing, press the Charger Stop button to stop the ATMOSPHERE™. Turn the ATMOSPHERE™ and Charger to OFF. NOTE: If the ATMOSPHERE™ sticks to the ceiling while flying, press the Stop button to stop the rotors. 3 sec FLYING INDOORS Location – Fly in a wide-open room away from breakable items. Avoid flying near vents and/or fans, as these may overpower the ATMOSPHERE™ and make it difficult to control. NOTE: Always get permission to fly your ATMOSPHERE™ indoors. a CAUTION: Never fly near your face. Keep rotor away from your fingers, hair, eyes and other body parts. Always lift off from a flat surface. DO NOT launch ATMOSPHERE™ near people or animals. Stay away from obstacles and electrical hazards. 2 SOLUTION move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function. Safety Precautions: - Keep hands, hair and loose clothing away from the rotors when power switch is turned ON. - Turn off charger and ATMOSPHERE™ when not in use. - Remove battery(s) from charger when not in use. - Parental guidance is recommended for the flight. - Keep your ATMOSPHERE™ in your sight so that you can supervise it at all times. - New alkaline batteries are recommended for use in charger to obtain maximum performance. - Users should keep strict accordance with the instruction manual while operating the product. - Your charger is tailor-made for the LiPo rechargeable battery used in your ATMOSPHERE™. Do not use it to charge any battery other than that in the ATMOSPHERE™. Special Note to Adults: - Parental guidance is recommended when installing or replacing batteries. Regularly examine the toy for damage. In the event of any damage, the toy must not be used until the damage has been repaired. This toy is not intended for children under 3 years old. Care and Maintenance: - Always remove batteries from the - Keep the toy away from direct heat. - Do not submerge the toy when it is not being used for a long period of time toy in water. This can damage the electronic assemblies. (charger only). - Wipe the toy gently with a clean damp cloth. Your ATMOSPHERE™ is equipped with a Lithium Polymer battery. SPECIAL LiPo BATTERY INSTRUCTIONS: Never charge battery unattended. - Charge battery in an isolated area. Keep away from flammable materials. - Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting. - Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot places. - Do not drop or subject to strong impacts. - Do not allow the batteries to get wet. - Only charge the batteries with the specified Spin Master™ battery charger. - Only use the batteries in the device specified by Spin Master. - Carefully read the instruction guide and use the batteries correctly. - In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. - Batteries must be recycled or disposed of properly. BATTERY SAFETY INFORMATION: Requires 6 x 1.5 V AA alkaline batteries (not included). - Batteries are small objects. - Replacement of batteries must be done by adults. - Follow the polarity (+/-) diagram in the battery compartment. - Promptly remove dead batteries from the toy. - Dispose of used batteries properly. - Remove batteries for prolonged storage. - Only batteries of the same or equivalent type as recommended are to be used. - DO NOT incinerate used batteries. - DO NOT dispose of this product in fire, as batteries inside may explode or leak. - DO NOT dispose of batteries in fire, as batteries may explode or leak. - DO NOT mix old and new batteries or types of batteries (i.e. alkaline/ standard). - DO NOT use rechargeable batteries. - DO NOT recharge non-rechargeable batteries. - DO NOT short-circuit the supply terminals. 3