Half Top Net, Jeep JK 2Dr - Motion-Tek

Jeep JK 2Dr 2007 - Present
Half Top Net
Installation Instructions
Contents include one Half Top Net and one package of extra strap keepers.


The Half Top Net is easier to install with the hard top removed or the soft top down or removed.
The Motion-Tek label on the Half Top Net locates in the lower right rear of the Jeep.
Half Top Net, Jeep JK 2Dr
Installing Strap into Cam Buckle - Route the strap as indicated in
each instruction set. Depress lever on cam buckle, which creates an
open slot in the buckle. Push pointed end of strap through open slot
from the back side of the buckle (opposite side of lever) . Pull strap
through and release lever.
(Do not tighten straps until all are attached.)
(Caution: Route straps so they do NOT wrap around
or restrict use of seat belts.)
Page 1
1. Installing Half Top Net—Place net on top of roll cage
aligning front of net with center crossbar as shown above.
Route the front strap off the side of roll cage and toward
the front around the inside of the vertical post. Then route
up on the outside of the front roll cage bar and through
the cam buckle as shown above.
3. Route the J-hook strap around the roll cage and hook
back into the ring as shown above. (Caution: Do Not restrict use of seat belts.) Route the flat hook toward the
side of the Jeep and hook under the edge of the Jeep
body in location shown above.
5. After the final adjustments
are made and the net is tight
and centered, slide each
strap end into the strap
keeper provided. The strap
keeper should be positioned
near the end of the strap to
secure as shown at left.
2. Pull the net toward the rear of the vehicle to keep tension as you attach the remainder of the straps. Wrap the
second and third straps on both sides around the roll
cage and through the cam buckle as shown above.
4. After all straps have been attached to the roll cage,
tighten the straps a little at a time starting with the front
and working toward the rear. The side straps should angle slightly toward the rear to ensure the net is pulled
tight. Make sure the net is centered in the roll cage and
the position on the speaker bar allows clearance for the
hard top bolt holes.
The hard and / or soft top may be installed with the
Jeep JK 2Dr Half Top Net attached to the roll cage.
The Half Top Net does not interfere with soft
top window installation or removal.
JKW HTN - Rev. 1
Page 2