93510 knee boards and pads

Transcription

93510 knee boards and pads
KNEE BOARDS AND PADS
93510
ASSEMBLY INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Specifications
Product Usage
Materials
For Smoothing Cement
Formed & Stamped Sheet Steel Board; each has two Nylon Straps and two
Metal Buckles
Knee Pads
Outside Dimensions
Red Molded Rubber Pads
25-5/8”L x 8-7/8”W x 2-5/8”H
Save This Manual
You will need the manual for the safety warnings and precautions, assembly
instructions, operating and maintenance procedures, parts list and diagram.
Keep your invoice with this manual. Write the invoice number on the inside of the
front cover. Keep the manual and invoice in a safe and dry place for future
reference.
Safety Warnings and Precautions
WARNING: When using product, basic safety precautions should always be
followed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this product!
1.
Keep work area clean. Cluttered areas invite injuries.
2.
Observe work area conditions. Keep work area well lit.
3.
Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will perform its
intended function. Check for any broken or damaged parts and any other
conditions that may affect its operation. Replace or repair damaged or worn
parts immediately. Check that any of the components are not cracked or
have splits that could affect the function and performance.
4.
Keep children away. Children must never be allowed in the work area. Do
not let them play with this product. This is not a toy or sporting equipment.
5.
Maintain this product with care. Clean off cement after use. Avoid rusting
by cleaning and drying after using this product. Do not allow the cement to
dry on the Knee Pads. If damaged, replace.
6.
Replacement parts and accessories. When servicing, use only identical
replacement parts.
SKU 93510
For technical questions, please call 1-800-444-3353.
Page 2
7.
Use the right product for the right job. There are certain work related
applications for which this product was designed. Do not use small equipment,
tools or attachments to do the work of larger industrial equipment, tools or
attachments. Do not use this product for a purpose for which it was not
intended.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
OPERATION
1.
It is recommended that only people with experience at smoothing cement
use this product.
Place your knees in the Red Rubber Knee Pads one at a time.
2.
Place your toes up against the Toe Brace. See Figure 1.
3.
Adjust the Straps (5) and (6) around the back of your knees as shown in
Figure 1. Connect the Buckles (3) and Fasteners (4). Tighten to fit
comfortably. Do not over-tighten which might cut off circulation.
Knee
Pads (2)
Toe Brace
Straps
(5 & 6)
Figure 1
4.
When finished using, unbuckle and carefully step out and away from the Boards.
Note: Rinse off any cement from the boards immediately. Dry throughly.
SKU 93510
For technical questions, please call 1-800-444-3353.
Page 3
Parts List
Part #
1
2
3
4
5
6
7
Description
Qty.
Knee Boards
Knee Pads
Buckle A
Fastener
Strap A
Strap B
Buckle B
2
2
2
8
2
2
2
Part
Part
Part 4
Part 5
Part 4
Part
Part 6
Part4
Part
Part
NOTE: Some parts are listed and shown for illustration purposes only and are not
available individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY
PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THat ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND
LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS
THERETO.
SKU 93510
For technical questions, please call 1-800-444-3353.
Page 4