GW 031B - GULIWER Electronics
Transcription
GW 031B - GULIWER Electronics
CONTACTLESS WATER CONTROL AUTOMATIC SHOWER CONTROL GW 031B water saving high hygiene contactless water control temperature regulation and flow regulation non-sensitive to ambient light non-reactivite to people accidentally moving near the flusher PROPERTIES reacts to presence of person standing in front of the sensor in distance to 0,5 m with automatic rinsing after 1 s water flow still 3 s after exit from the shower non-reacts to people accidentally moving near the flusher adjustable closure sensitivity the equipment is not determined for the assembly opposite to each other Instructions for parametrs adjustement: - this type isn't intended for parameters remote control, parameters adjustment by trimmers Technical data Stainless steel cover Necessary installation pocket Supply voltage Power input Range Recomanded working pressure Water flow Water inlet Water outlet 174 x 202 x 10 cm 150 x 180 x 80 cm AC 20 V 1,2 W (state of rest) 10,7 W (during closure) 0,5 m 0,1 - 1 MPa 12 l/min. external thread G 3/4“(1/2“) external thread G 3/4“ (1/2“) Guliwer electronics, s.r.o., Dukelských hrdinù 1011, 563 01 Lanškroun, Czech Republic Tel./fax: +420 465 461 535 (sale) +420 465 461 536 (techn. information) Mobil: +420 603 162 962; +420 603 843 695; e-mail: [email protected]; http: //www.guliwer.cz Wiring and assembly diagram 1 2 3 4 5 6 7 8 9 - supply water pipeline - stainless steel cover with electronics - mounting frame, connecting nut - sensor sensing zone - spray jet shower - power supply - electromagnetic valve - mixing valve - outlet pipe Recommendations for installation - water and electro installation (in the case of connection with main supply) must agree with specified technical standards and can be made only by professionally competent persons - device is installed into the installation pocket under the spray jet shower in height cca 130 cm on its center line - the device isn't determined for the assembly opposite to each other - before connection to the water distribution, it's recommended to flush water supply from dirts and deposits (in order to prevent possible damage of electromagnetic valve) - the mode of installation is evident from the enclosed diagram - the sensor sensitivity will be adjusted by the trimmer on the rear side of electronics - is recommended to seal the cover by the filler Recommended accessories GW 091Z GW 092Z - external power supply 230/20 V AC, for simultaneous feed of max. 3 shower controls - external power supply 230/20 V AC, for simultaneous feed of max. 5 shower controls Guliwer electronics, s.r.o., Dukelských hrdinù 1011, 563 01 Lanškroun, Czech Republic Tel./fax: +420 465 461 535 (sale) +420 465 461 536 (techn. information) Mobil: +420 603 162 962; +420 603 843 695; e-mail: [email protected]; http: //www.guliwer.cz
Similar documents
GW 031A - GULIWER Electronics
- this type isn't intended for parameters remote control, parameters adjustment by trimmers
More informationGW 021A - GULIWER Electronics
deposits (in order to prevent possible damage of electromagnetic valve) - the mode of installation is evident from the enclosed diagram - the sensor sensitivity and the flushing time will be adjust...
More information