gc7a1 manual

G&G 4X Magnification Scope (OD Green)
Front Sling Swivel
INSTRUCTION MANUAL
GC7A1
Dust Cover
Flash Suppressor
Magazine Release
Fixed Stock
Charging Handle
Front Sight
Fire Mode Selector
Rear Sling Swivel
Tri-Rail Mount (Black)
FIRING MODE & SAFETY
Handguard
Trigger
Trigger Guard
450R Hi-Cap Magazine
► Never operate the selector switch while pulling
the trigger.
Otherwise, malfunctions may occur.
► Pulling the trigger with the Selector being set at
safe mode may damage the air gun.
► Always set the safety mode setting immediately
after firing.
Safety On
Semi Auto
The trigger cannot be pulled
BATTERY INSTRUCTIONS
► Please use only CE approved quality batteries. Do not
use low quality or non approved batteries to avoid damage to
the gun.
► Please use either 8.4V or 9.6V battery, if different voltage
used, it might damage the product.
► Remove the battery from the product when it is not in use.
► Do not use battery in moist or wet conditions. Do not
dispose of battery in fire. Avoid damage to plug terminal.
Single shot
Full Auto
Grip
COMPONENTS
Automatic firing
SCOPE INSTALLATION
G-11-022
G-11-023
WINDAGE ADJUSTMENT
Click
G-11-048
G-11-051
1.Charge up the battery.
2.Battery charging is complete when
charger shows a green light
Pull down on latch to open stock battery
compartment cover
Connect the plug and make sure it clicks to
lock in and insert battery into compartment.
Close the battery cover.
1
1
LOADING THE MAGAZINE
CW (Poi left)
CCW (Poi right)
► It is strongly recommended the use of G&G BB
pellets only. Using low quality BB pellets will shorten
product life span and void product warranty.
2
1.Place 4X Magnification Scope on your airsoft gun.
2.Turn the knobs clockwise to secure in place.
1.Press the magazine release.
2.Pull the magazine out of the receiver.
HOP-UP ADJUSTMENT
► Dust cover must be manually
Best Position.
opened to adjust Hop-Up.
► Do not catch your fingers in the
dummy bolt.
► Never hold the gun sideways
as the BB pellets will curve right
or left.
Open the magazine cover.
Load G&G 5.95mm BB pellets into the
magazine.
ELEVATION ADJUSTMENT
After the BB pellets have been loaded,
close the cover and turn the gear on the
bottom until the sound changes.
Too much Hop-up.
( Turn the adjust lever toward Normal )
Not enough Hop-up. ( Turn the adjust lever toward Hop )
or Too much Hop-up. ( Turn the adjust lever toward Normal )
Turn clockwise to adjust point of impact to the left.
Turn counter clockwise to adjust point of impact to the right.
2
Turn to Normal
Turn to Hop
The dial at the rear of the scope can be used
to adjust the elevation of the point of impact.
INSTRUCTION MANUAL
GC7A1 is based off the C7A1. The C7A1 assault rifle is an improved version of the basic C7 combat
rifle, incorporating a low-mounted optical sight. The C7 rifle is a Canadian adaptation of a U.S. firearm known as the M16A1E1. The C7A1 eliminates the carrying handle of the C7 and substitutes an
optical sight. The C7A1 assault rifle is the personal weapon for most soldiers in Canada and outside
the country.
INSTALLATION TRI-RAIL MOUNT
Put the Tri-Rail Mount below the front
sight.
GC7A1
MAINTENANCE
Remove the magazine.
Fasten the screw.
OPTIONAL PARTS
TROUBLE SHOOTING
Be aware to have the rod facing down
and reaching to the end, and remove
clogged pellets.
Return the hop up dial to normal position
and insert the cleaning rod from the lead
edge of the inner barrel.
If operation and noise becomes
abnormal, the motor might
need to be adjusted.
No operation
Please use flathead screwdriver to
adjust the height of the motor for
optimal performance.
Check and make sure the motor wires
are connected to the motor.
G-12-020
551 Graphic Sight
Fasten the interface knob.
1
7A
GC
G-12-008
30mm AP Red Dot Sight
-02
1
1-0
7A
Install the visible laser.
Check and make sure the battery is
connected properly.
OPTIONAL PARTS
GC
G-12-001
No operation
-03
A1
7
GC
-04
A1
7
GC
-06
A1
7
GC
-05
A1
PARTS LIST
7
GC
for GC7A1
GC7A1- 01
Flash Suppressor
GC7A1- 10 Grip Set
GC7A1- 02
Front Sight Set
GC7A1- 11 Fixed Stock Set
GC7A1- 03
Upper Handguard Set
GC7A1- 12 Inner Barrel Set
GC7A1- 04
Delta Ring Set
GC7A1- 13 Hop Up Set
GC7A1- 05
Upper Receiver Set
GC7A1- 14 Gear Box Set
GC7A1- 06
Outer Barrel Set
GC7A1- 15 G&G 4X Magnification Scope
GC7A1- 07
Tri-Rail Mount
GC7A1- 08
Lower Receiver Set
GC7A1- 09
Lower Handguard Set
TAIWAN
Sales Dept. [email protected] , [email protected]
Technology Support Dept. [email protected]
PR Dept. [email protected]
-08
A1
7
GC
G
7
GC
3
1-1
7A
-14
A1
U.S.A.
7
GC
E-mail [email protected]
Los Tel : +1-626-581-0101
Angeles Fax : +1-626-581-1011
1122 Coiner Court,
City of Industry,
CA 91748 (U.S.A.)
Dealer
1
1-1
G2-201306-08-英
G
A
C7
0
1-1
7A
GC
Taipei Tel : +886-2-2692-2000
Fax : +886-2-2692-4000
11F-3., No.27, Lane 169, Kangning St. Shijr City,
Taipei County 22180, Taiwan (R.O.C.)
2
1-1
A
C7
-09
A1
Chang Tel : +886-4-798-9000 Fax : +886-4-798-9900
Hua No.999, Zhonghua Rd. Shengang Township,
Changhua County 50955, Taiwan (R.O.C.)
-15
A1
7
GC
GC
Headquarters
7
1-0
7A
GC
► You may purchase all of
the groups’ parts
from G&G support Dept.
► E-Mail:
support@guay2com