Loading the Adapter Ear piercing Stud and Instrument After

Ear piercing Stud and Instrument
ADAPTER
(installed)
PLUNGER
PLUNGER KNOB
CLASP
EARRING
HEAD
POST
STUDS
CLASPS
CLASP
RETAINER
TRIGGER
BLISTER PACK
PLASTIC MOUNT
CAFLON Instrument
Loading the Adapter
Uncocked position
Make sure Adapter is fully seated
Pull Plunger back to cock
Insert Adapter into Plunger Shaft
Return in uncocked position
After piercing care is the
most important factor
in keeping pierced ears
healthy.
Position plastic mount
with stud on the bottom
and the clasp at the top.
Loading the Instrument with stud and clasp
Insert one stud head into
stud adapter then pull the
mount straight up to release
the stud from the mount.
Keep the instrument in the
upright position, slide the
corresponding clasp into the
clasp retainer at the end of
the instrument.
Caflon ear piercing instrument
with installed stud and clasp
Ear Piercing with CAFLON Instrument
Carefully release the trigger
and pull the instrument
straight down from the ear.
Place the ear between
the clasp retainer and
the stud. Align the point
of the stud with the mark
on the ear. Slowly squeeze
the trigger until the ear is
held securely by the
instrument.
Keeping alignment
to the mark, continue
to squeeze the trigger
until it releases the
plunger.
The ear will be pierced
and the clasp will be
automatically installed
on the stud’s post
with proper spacing.
Repeate procedure for additional ear piercings.
Give to the customer the signed after-piercing care
instructions to take home with them.