Motorola V180 Motherboard Replacement

Motorola V180 Motherboard Replacement
Motorola V180 Motherboard Replacement
Written By: Tyler Knisley
INTRODUCTION
The following repair instructions will guide you through the removal of your Motorola V180
Motherboard. However, be careful as some parts do easily fall off.
TOOLS:
T6 Torx Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 3
Motorola V180 Motherboard Replacement
Step 1 — Battery

Flip over the phone, press down the button and slide off the back cover.

Remove the battery.
Step 2 — Keypad

Locate the four screws on the back of the phone.

Using your T6 Torx Screwdriver, unscrew these screws.

Remove the SIM card located on the back of the phone.
 A ribbon near the antenna is still attached to the motherboard. Do not break this ribbon.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 3
Motorola V180 Motherboard Replacement
Step 3 — Motherboard

Unclip the pronged rectangle connector ribbon attached to the motherboard.

Remove the motherboard.
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2016-09-13 04:54:27 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 3