Suzuki FA50 Moped Exhaust Pipe Replacement
Transcription
Suzuki FA50 Moped Exhaust Pipe Replacement
Suzuki FA50 Moped Exhaust Pipe Replacement Suzuki FA50 Moped Exhaust Pipe Replacement Use this guide to remove the exhaust pipe from your Suzuki moped. Written By: Miroslav Djuric INTRODUCTION Use this guide to remove the exhaust pipe from your Suzuki FA50 moped. TOOLS: Socket 10mm (1) Socket 12mm (1) Phillips #2 Screwdriver (1) © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 3 Suzuki FA50 Moped Exhaust Pipe Replacement Step 1 — Exhaust Pipe Use a #2 Phillips screwdriver to remove the heat shield from the muffler. Step 2 There are two 10 mm hex nuts attaching the muffler to the engine. Make sure you remove both of them before proceeding to the next step. © iFixit — CC BY-NC-SA www.iFixit.com Use a 10 mm socket wrench to unscrew the two hex nuts. Page 2 of 3 Suzuki FA50 Moped Exhaust Pipe Replacement Step 3 Use a 12 mm socket wrench to unscrew the third and final hex nut that holds the muffler in place. Make sure to support the muffler with your hand while removing this nut, otherwise it may just fall to the floor. To reassemble your device, follow these instructions in reverse order. This document was last generated on 2016-09-23 10:53:23 PM. © iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 3
Similar documents
Motorola V180 Motherboard Replacement
Flip over the phone, press down the button and slide off the back cover.
More information