VFSO57

Rola Roof Racks
5 Year Warranty
Vehicle Compatibility Guide
This Fit Kit is compatible with the following vehicles.
VFSO57
Revision D
Rack System: (“Rola Roof Rack”). The Rola Roof Rack incorporates three components:
Make
End Supports
Holden
Commodore 4D Sedan VT
Fit Kit
Holden
Commodore 4D Sedan VX
10/00 -10/02
Cross Bars
Holden
Commodore 4D Sedan VY
10/02 -08/04
Cequent warrants that, subject to the exclusions and limitations below, the Rola Roof Rack will be free from
defects in materials and workmanship for a period of 5 years commencing on the date of sale by the
authorised Rola stockist to the original purchaser of the entire Rola Roof Rack, including the End Support, Fit
Kit and Cross Bars.
If a defect appears in the Rola Roof Rack before the end of the warranty period and Cequent finds the Rola
Roof Rack to be defective in materials or workmanship, Cequent will, in its sole discretion, either:
1.
Repair the Rola Roof Rack or the defective component of the Rola Roof Rack free of charge;
2.
Replace the Rola Roof Rack or the defective component of the Rola Roof Rack; or
3.
Refund the purchase price of the Rola Roof Rack to the original purchaser.
Cequent reserves the right to change the design, specifications or composition of the Rola Roof Rack without
notice and without liability.
Cequent reserves the right to replace defective products or components with products or components of
similar quality, grade and composition, where an identical product or component is not available.
Goods presented for repair may be replaced by refurbished goods of the same type rather than being repaired.
Refurbished parts may be used to repair the goods.
Model
Year
09/97 -10/00
Holden
Commodore 4D Sedan VZ
08/04 -08/07
Holden
Caprice Statesman 4D Sedan WH
06/99 -04/03
Holden
Caprice Statesman 4D Sedan WK
05/03 -07/04
Holden
Caprice Statesman 4D Sedan WL
08/04 -07/06
Holden
Crewman 4D Ute
08/03 -08/07
Holden
Commodore 2D Ute VU
12/00 -09/03
Holden
Commodore 2D Ute VY
10/03 -07/04
Holden
Commodore 2D Ute VZ
08/04 -07/07
VEHICLE COMPATIBILITY & WARRANTY
The 5 year warranty only applies where the entire Rola Roof Rack is purchased in one transaction and is
installed and used together.
The 5 year warranty does not apply where:
1.
The Rola Roof Rack is not installed in compliance with the fitting instructions provided;
2.
The Rola Roof Rack is not used as intended or designed;
3.
Any part of the Rola Roof Rack, such as the End Supports, Fit Kits, or Cross Bars, is used with
other products or components notintended to be used in conjunction with the modular Rola Roof
Rack system;
4.
The Rola Roof Rack has been on-sold or assigned by the original purchaser;
5.
The Rola Roof Rack has been modified or repaired by someone other than Cequent or an authorised
Rola stockist;
6.
Cequent cannot establish any fault in the Rola Roof Rack after testing;
7.
The Rola Roof Rack has been subject to abnormal conditions, including fire, water, humidity,
pressure, stress or similar;
8.
The defect in the Rola Roof Rack has arisen due to abuse, misuse, neglect or accident;
9.
The defect in the Rola Roof Rack has arisen due to the unlawful or unusual operation of the vehicle
to which it is fitted;
10.
The defect in the Rola Roof Rack has arisen due to the purchaser’s failure to properly assemble,
install, fit, maintain or use the Rola Roof Rack in accordance with the specifications and instructions
provided by Cequent.
IF YOUR VEHICLE IS NOT LISTED HERE
We are constantly adding vehicles to these kits, If the set-up instructions for your vehicle do not
appear in this guide, go to
up information
www.rola.com.au/fitkits/vcs057.pdf
for your set
For safety and use instructions, please refer to any General or Specific Fitting Instructions and Use & Care
Instructions enclosed with the Rola Roof Rack or on our website at www.rola.com.au.
This warranty does not extend to fair wear and tear. Warranty claims can be made by contacting Cequent
directly using the details below. A warranty claim must be accompanied by proof of purchase (such as receipt)
and details of the alleged defect.
It is the purchaser’s responsibility to arrange and pay for any warranty claims, including the shipment of goods
to Cequent for inspection. The purchaser may seek reimbursement from Cequent for the costs of such
activities, providing Cequent notifies the purchaser in writing that a warranty claim is justified. Any such
claims must be made in writing via post or email.
The benefits of this warranty are in addition to any rights and remedies imposed by Australian State and
Federal legislation that cannot be excluded. Nothing in this warranty is to be interpreted as excluding,
restricting or modifying any State or Federal legislation applicable to the supply of goods and services which
cannot be so excluded, restricted or modified.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure. Cequent makes no express
warranties or representations other than set out in this warranty.
The repair or replacement of Rola Roof Racks or part there of, or a refund of the purchase price of
the Rola Roof Rack, is the absolute limit of Cequent’s liability under this express warranty.
Cequent, a division of TriMas Corporation Pty Ltd. 49 Pacific Drive, Keysborough, VIC, 3173.
Phone 1800 812 017.
www.rola.com.au.
For detailed warranty information visit us online.
ABN 60 004 546 543
Please complete the Warranty form on the reverse side and post to:
PO BOX 4050
Dandenong South
VIC 3164
Australia
For more information visit www.rola.com.au
Installation Guide
follow the vehicle specific instructions to set up your racks correctly
Make
Model
Door/Body
Series
Released
Finished
Strap
No. / Location
Strap Bolt
Position
7007
Holden
Commodore
4D Sedan
VT
09/1997
Holden
Commodore
4D Sedan
VX
10/2000
4D Sedan
VY
10/02
Place strap bolt
facing up
7007
Holden
Commodore
4D Sedan
VZ
08/2004
Caprice Statesman 4D Sedan
WH
06/1999
Strap Bolt Position
N/A
N/A
N/A
N/A
04/2003
Front
N/A
Place Strap bolt
facing down
Place Strap bolt
facing up
Customer Details
N/A
Pad Adaptor Requirement
(shown from the underside)
27-0845
Front LH
27-0847
Rear LH
27-0844
Front RH
27-0846
Rear RH
Name
Address
Suburb
Equal =
Equal =
(x) mm
Concealed
Equal =
Equal =
(x) mm
Extended
Your roof rack is at its strongest and
looks its best when the cross bar is
centred equally within the end
supports.
Measure the distance between end
supports on the underside of the
bar. Slide the end supports until the
distance between them is correct
and the cross bar is centred.
Lock the bars in place using the
locking lever and proceed to the
next step.
Dealer/Reseller
Suburb
End suport distance from mid-pillar
A
B
00mm 00mm
Vehicle/Product Details
Vehicle Make
Model/Year
Front
N/A
If specified to do so, fit the supplied Pad
adaptors to the feet of each End Support in
the location indicated.
The numbers shown to the left correspond to
the correct location of the feet pads. The
numbers are moluded in the underside of
each part.
The numbers shown above in the vehicle
table correspond to the correct adaptor
block to be inserted in the foot pad (if
required)
Refer to step 1 of the fitting instructions for
more information.
Distances for setting out your racks are
defined from the mid pillar of the
vehicle. Both forward and rearward
measurements are given to the centre of
the straps.
Take care to set your racks out
as shown to ensure your racks fit and
perform as they have been design to.
Right & Left hand sides of the vehicle are
defined as you would be when sitting in
the vehicle
RH
Product/Part Numbers
Mid pillar
Please tick if you do not wish to receive product information or marketing offers
from Rola.
N/A
N/A
Front 250mm
Rear 400mm
Store Details
End Support Distance and Bar length
N/A
Front 945mm
Rear 945mm
To ensure smooth handling of any warranty claims, please complete the form below and send to the address indicated overleaf.
The strap bolt
N/A
Front 250mm
Rear 400mm
7007
Rola Roof Rack Warranty Registration Card
The strap bolt position is important
to the correct set-up of your end
supports.
Refer to the vehicle specific image
and follow the instructions for
correct installation position.
N/A
N/A
N/A
Place strap bolt
facing up
Front 250mm
Rear 400mm
Front 945mm
Rear 945mm
Front
7007
Holden
N/A
N/A
7007
08/2007
Place strap bolt
facing up
N/A
Front 250mm
Rear 400mm
Front 945mm
Rear 945mm
Front
N/A
End Support Distance
from Mid Pillar
Front 250mm
Rear 400mm
7007
08/2004
N/A
N/A
Front 945mm
Rear 945mm
Front
7007
Commodore
7007
10/2002
Place strap bolt
facing up
Holden
Front 945mm
Rear 945mm
Front
7007
Pad Apaptors
7007
10/2000
Place strap bolt
facing up
End Support Distance
and Bar length (x)
Front
LH
ROLA Ambassador
Josh Sanders - Australian Pro Wakeboarder
ROLA Ambassador
Niki Gudex - Australias Number One
Female Mountain Biker
ROLA Ambassador
Ryan Hipwood - Australian Pro Surfer
Installation Guide
follow the vehicle specific instructions to set up your racks correctly
Make
Model
Door/Body
Series
Released
Finished
Strap Bolt
Position
Strap
No. / Location
7007
Holden
Caprice Statesman
4D Sedan
WK
05/2003
Caprice Statesman
4D Sedan
WL
08/2004
Place strap bolt
facing up
Crewman
4D Ute
08/2003
Place strap bolt
facing up
Commodore
2D
Ute
VU
12/2000
2D
Ute
VY
10/2003
2D
Ute
VZ
08/2004
Front 945mm
Rear N/A
Front
7007
Commodore
na
07/2004
Place strap bolt
facing up
Holden
Front 945mm
Rear N/A
Front
7007
Commodore
na
09/2003
Place strap bolt
facing up
Holden
Front 945mm
Rear 945mm
Front
7007
Holden
7007
08/2007
07/2007
Place strap bolt
facing up
Front
na
N/A
N/A
Front 945mm
Rear 945mm
Front
7007
Holden
7007
07/2006
Pad Apaptors
N/A
Front 945mm
Rear 945mm
Front
7007
Holden
7007
07/2004
Place strap bolt
facing up
End Support Distance
and Bar length (x)
Front 945mm
Rear N/A
End Support Distance
from Mid Pillar
N/A
N/A
Front 250mm
Rear 400mm
N/A
Front 250mm
Rear 400mm
N/A
N/A
N/A
N/A
Front 250mm
Rear 400mm
N/A
N/A
N/A
N/A
Front 250mm
Rear NA
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Front 250mm
Rear NA
N/A
Front 250mm
Rear NA
N/A
N/A