Go Green and Recycle Your Water with a Hellenbrand Water

Comments

Transcription

Go Green and Recycle Your Water with a Hellenbrand Water
Go Green and Recycle Your Water with
a Hellenbrand Water Management System
“Patent Pending”
• Reclaim approximately 65% of the regeneration water from your water softener and use it to flush
your toilets and/or urinals.
• The portion of the regeneration water with salt water is automatically diverted to drain.
– An optional brine reclaim feature would allow the highest concentration of salt/brine water to be re-used on the next regeneration for additional water and salt savings.
• That’s water savings on the front end to buy it.
• Less demand on the water utility for pumping and treatment to supply your water.
• Savings on the back end for sewer charges.
• Additional savings on water that would have typically been softened, saving you on salt and less
chlorides for the waste water treatment plant to treat.
Additional Reclaim Opportunities
•
•
•
•
100% of the reject water from an R.O. System, resulting in a “zero” waste R.O.
100% of the water from your humidification system, such as Aprilaire™.
100% of your water from your dehumidification system.
100% of the condensate water from your furnace.
Built In Disinfection & Repressurization System
•
•
•
The holding tank maintains chlorine residual for proper disinfection.
The repressurization system supplies adequate pressure
and volume to “re-use” this water to flush your toilets.
A built-in water monitor, allows for softened water to be added to
the tank when the reclaim volume does not meet flushing needs.
Available On These Systems
• ProMate-6 Series (shown here)
• H125 Series
• H151 & H200M Commercial Systems
Hellenbrand Water Management System
Additional
Water Reclaim
Opportunities
Optional Reclaim Water from R.O. Drain,
Furnace Condensate, Humidifier/Aprilaire™
Drain or De-Humidifier Collection.
Soft Water Outlet
Raw Water Inlet
Water Softener
Drain Line
Non-potable water for
toilets and/or urinal supply
only. “Do Not Drink?”
Low
Water
Refill
Line
(Purple Piping)
Reclaim Tank
Air Gap/Vent
Delivery Pump Options
109250
– 2.15 GPM @ 40 PSI, 110V
107401
– 6 GPM @ 49 PSI, 110V
– 12 GPM @ 36 PSI, 110V
To Drain
Delivery Pump
Reclaim Tank
Water Softener
Salt Tank
Water Management System Savings for Water, Salt and Chlorides
Calculation of water saved per regeneration: (Backwash Minutes + Slow Rinse Minutes) x (Drain LineWater
Flow
Control System
Management
Size “GPM”) + (Slow Rinse Rate @ 40 PSI x 12 Minutes) or approximately 65% of the water typically used to regenerate.
NAME
DATE
DWG DESCRIPTION:
DRAWN
ENG APPR.
PROPRIETARY AND CONFIDENTIAL
DIMENSIONS ARE IN INCHES
TOLERANCES: X" +/- 2"
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
HELLENBRAND INC. ANY REPRODUCTION REV DESCRIPTION:
NOTE:
IN PART OR AS A WHOLE WITHOUT THE
INTERCONNECT PIPING IS TO BE PROVIDED BY INSTALLER. ALL PIPING
WRITTEN PERMISSION OF HELLENBRAND INC.
AND FIXTURES MUST CONFORM TO LOCAL AND STATE PLUMBING CODES. IS PROHIBITED.
Salt and chloride savings are directly related to water savings
Hellenbrand
Assumptions:
Water Reclaim
• Regeneration Frequency is based on every (4) days or 90 Regenerations/Year
• Older 1.0 Cu. Ft. Water Softeners = 28,000 grains @ 10lbs. Salt
• Water Hardness = 20 GPG
• Chloride Discharge Reduction Equals:
Annual Gallons Saved x 20 GPG Hardness
• Example: 1836 Gallons x 20 = 36,720 Grains Saved
• 36,720 / 28,000 = 1.3 Regenerations/Year
• 1.3 x 10 Lbs. = 13 Lbs. Salt
• 13 Lbs. x .606 = 7.88 Chlorides not discharged by reclaiming softener regeneration water
Softener Size
Water Saved per Regeneration
Annual Gallons Saved
DWG. NO.
Chloride Discharge Reduction
24 k capacity
20.40 Gallons
1836.0
7.88 lbs. Chloride
32 k capacity
23.76 Gallons
2138.4
9.09 lbs. Chloride
48 k capacity
30.48 Gallons
2743.2
11.87 lbs. Chloride
Softener Size
Water Saved with
Systems 15+ Years Old
Annual Gallons Saved
Chloride Discharge Reduction
24 k capacity
40.56 Gallons
3650
15.79 lbs. Chloride
32 k capacity
49.70 Gallons
4473
19.36 lbs. Chloride
48 k capacity
60.58 Gallons
5452
23.59 lbs. Chloride
Reclaim Tank Selection
Max Capacity
Max Size Standard Softener
1840 (DxH)
32 Gallons
48 k capacity
2450
75 Gallons
120 k capacity
3050
133 Gallons
180 k capacity - 18” tank
For systems larger than 180k, contact Hellenbrand Technical Services.
Max capacity is calculated by multiplying tank
height - 8” (for safety factor) times gallons per
inch of water height.
18” – 1.1 gallons per inch of water height
24” – 1.96 gallons per inch of water height
30” – 3.06 gallons per inch of water height
800417
Updated-3/19/12-LBRY
REV.

Similar documents