rhinestone application

rhinestone application
1
Select a rhinestone template. Do
NOT resize it. Feed the template
material into the Silhouette on a
cutting mat. Select media type
“rhinestone template material” in
Silhouette Studio® and cut.
5
Once all of the rhinestones are
positioned face-up in the template,
cover the design with a piece of
rhinestone transfer tape.
2
Peel the template material off the
backing leaving the circle cutouts
behind. For best results, peel the
material off in one quick motion.
6
Affix the template material to a
rhinestone backing board.
Pour rhinestones onto template.
7
Lift the transfer tape off the
template and position the
design on the desired surface.
The rhinestones will stick to
the transfer tape.
8
Remove iron, cloth and transfer
tape. If rhinestones continue to
stick to the transfer tape, replace
cloth and iron again at a hotter
setting.
9
Turn the garment inside out and
repeat step 7. This will pull the
glue into the fabric.
3
Wash and dry clothes
inside out. Only use designs
marked as rhinestone
templates.
Use extreme caution when
operating a hot iron. Keep
out of reach of children.
Place a thin cloth over the design
and press down on top with a
heated iron for 45-60 seconds.
The iron should be set to the
“wool” setting.
4
Gently brush the rhinestones in
a circular motion until all the
holes are filled. Brush away
excess rhinestones.