Inground Trampoline Installation Timeline

Timeline for a typical Inground Trampoline Installation
With our new design of In Ground Trampolines installing them is not a 5 day job like the traditional models
and can be done in less than a day. Here is a timeline of a 10ft trampoline that was recently installed.
Marking out hole
8am: We agreed with the customer where to site the trampoline and marked out the circumference of
the hole. This was for a 10ft trampoline so the hole was marked out to 11ft.
Digging the hole
8.30am: We started by removing the turf from the outside by hand and keeping nearby to use again
to fill in on the outside at the end of the project. The digger then got to work to start digging down to a depth
of 25cm in the full diameter of the hole.
9.30am: Now well into the hole dig, we removed the soil down to a depth of 25cm throughout the
11ft diameter.
Timeline for a typical Inground Trampoline Installation
Starting the inner hole
10.30am: Having taken out 25cm of soil across the whole 11ft diameter,it was then a case of marking out
an inside 8ft diameter circle for the inner hole.
Finished Inner Hole With Ledge
11:30am: An hour or so later the inner hole was dug and all the excess soil removed, ready for a
soak-away and weed membrane.
Timeline for a typical Inground Trampoline Installation
Making The Trampoline And Retaining Wall
12:30pm: In a separate area we then built the trampoline and put the retaining wall on - the whole process
took about 45 minutes. We then dropped the trampoline in the hole, fitted the vented surround pads and did
the finishing landscaping.
Enjoying The Finished Trampoline Install
2:00pm: Job done! Just in time before the kids got home from school.
For further details on our Range of In Ground and Above Ground Trampolines
please call 1300 393 004 or visit www.oztrampolines.com.au