Technical data sheet

CLADDING MORTARS
®
MORCEMSEC ENLUCIDO
®
MORCEMSEC ENLUCIDO
MORCEMSEC
®
PLASTER
DESCRIPTION
COMPOSITION
FEATURES AND
APPLICATIONS
SUBSTRATES
INSTRUCTIONS FOR USE
Dry mortar to finish as a thin coat on existing renders.
Rainwater-proof and permeable to water vapour.
Product based on high resistance cement, selected aggregates, and other additives.
To be applied indoors and outdoors.
Excellent adherence.
Waterproof cladding.
Permeable to water vapour, allowing the substrate to breathe.
Very flat finishes.
Its high plasticity allows an easy application.
Up to 0,5 cm thickness.
Renders of cementitious mortars.
Substrates must be clean and free of dust, oil, paint, loose particles, etc.
In case of hot or windy weather conditions or when applying over absorbent substrates, it is advisable to
wet the substrate and wait till the thin layer of water disappears.
Do not apply on gypsum or on paint.
MECHANICAL APPLICATION
Fix the optimum proportion water/mortar according to the chosen pump (section and hose length) and
external weather conditions. Start with 20% proportion and modify it gradually until you achieve the
appropriate consistency.
It is important to maintain the same variables affecting the features of the applied mortar (distance to the
wall, angle of application and water proportion).
MANUAL APPLICATION
Add water and mix by hand or mechanically until it takes on an even and workable consistency.
Spread the mixed product over the substrate with the use of a trowel.
Let stand as long as necessary and then float finish.
1/2
Rev. 01/07 · This revision cancels all previous ones. Please, obtain the latest version from our web site · www.grupopuma.com · (+34) 957 76 40 40
Dry plastering mortar for very smooth finish
CLADDING MORTARS
MORCEMSEC ENLUCIDO
CAUTIONS AND
RECOMMENDATIONS
PACKAGING
NOTE
Do not apply below 5ºC nor above 30ºC.
Do not apply when there is a risk of frost, rain, strong wind or direct sunlight.
For a thickness of over 0,5 cm, it is advisable to apply the product in two coats.
In extreme weather conditions (strong winds or high temperatures) it is necessary to water the product
with light sprinklers the day after applying it.
25 kg plastic-lined paper bags.
Shelf life: 1 year in sealed original packaging, sheltered from weather conditions and humidity.
Instructions of use are given based on our testing and knowledge and do not imply any commitment. Said
instructions do not free the user from examining and verifying the product for its correct use.
The manufacturer's liability is limited to the value of the used goods. Complaints must be accompanied with
the originall package to allow proper traceability.
TECHNICAL DATA
(Statistical data obtained under standard conditions)
2/2
Aspect
WHITE or GREY powder
Water vapour permeability
≤µ25
Adhesion
≥0,3 N/mm
UNE-EN 998-1 Classification
GP CSIV W2
Approximate yield
8 Kg/m per cm of thickness
2
2
Rev. 01/07 · This revision cancels all previous ones. Please, obtain the latest version from our web site · www.grupopuma.com · (+34) 957 76 40 40
®