J13311 Sun Canopy.indd

Tech Sheet
JK part number:
J13311
Page 1 of 2
Just Kampers Sun Canopy
1. Lay the nylon canopy on the ground with the velcro strips facing up.
Connect the black fibreglass poles together and lay across the canopy from corner to corner then attach these poles
to the canopy using the four Velcro strips provided. In the centre of the canopy there is a drawstring, use this to tie
the two fibreglass poles together.
2. The front sun canopy rail (the rail furthest away from the vehicle) attaches to the front of the canopy material.
Piece together this rail as shown below. The metal bars with a plastic cap and hinged pin go on each end. These slide
into the Velcro pockets in the corners of the canopy (as pictured), add the leg connection poles in between the outer
two Velcro fixing points. Make sure the Velcro sleeves are done up.
The rear rail is identical with the exception of the sun canopy legs.
www.justkampers.com
0345 1204582
Just Kampers, Unit 1 Stapeley Manor, Long Lane, Odiham, Hants. RG29 1JE
NB. Please note that whilst every attempt is made to ensure that these instructions are as
accurate and clear as possible, we cannot be held responsible for misinterpretation of these
instructions or for any subsequent accident or damage caused through mis-fitted parts.
Tech Sheet
JK part number:
J13311
Page 2 of 2
3. Now push the black fibreglass poles on to the hinged pins which are located on the main front and rear rails.
This gives the Sun Canopy its curved shape.
Add the legs to the front rail and gutter clamps to the rear rail or sucker clamps for vehicles without gutters as shown
(available separately).
4. Finally attach the sun canopy to your vehicle using the gutter clamps provided or with a set of sucker clamps which
are sold separately, then adjust the legs to the height of your choice and tie the canopy down using the guy ropes
provided.
AVAILABLE SEPARATELY
Sold in packs of 3, these suction
clamps work horizontally or vertically
and are designed to mount awnings
and sun canopies to vehicles without
traditional rain gutters. Takes seconds
to fit with no tools or drilling.
Very strong suction.
Gutter clamps for older vehicles
Sucker clamps for vehicles
without gutters
www.justkampers.com
0345 1204582
Part no. J13006
Just Kampers, Unit 1 Stapeley Manor, Long Lane, Odiham, Hants. RG29 1JE
NB. Please note that whilst every attempt is made to ensure that these instructions are as
accurate and clear as possible, we cannot be held responsible for misinterpretation of these
instructions or for any subsequent accident or damage caused through mis-fitted parts.