Easy Lined Apron Materials: Courtesy of:

Easy Lined Apron
Courtesy of: http://inkandspindle.blogspot.com/
Materials:





Patterned fabric for front (65cm x 100cm / 26" x 40")
Plain fabric for lining (65cm x 100cm / 26" x 40")
Medium weight cotton twill tape approx. 25mm / 1" wide (2.2m / 87")
Two metal D rings to suit the twill tape
Contrasting fabric for front pocket, optional (40cm x 23cm / 16" x 9")
Instructions:
1) Print & cut out the apron pattern
2) Take your front and lining fabrics and fold them in half lengthwise.
3) Lay the pattern piece on top of your front fabric, with the edge marked ‘fold’ in line
with your center fold. Pin the pattern piece in place and cut the shape out through
both layers of fabric. Repeat with the lining fabric.
4) From your contrasting fabric, fold and cut out the pocket piece as above.
5) For the pocket: Fold down the top edge by 1cm (3/8") and press. Repeat with the
side, bottom and corner edges. Fold down the top edge a second time by 1cm (3/8")
and press - this creates a neat clean finish to the top of your pocket.
6) Stitch two rows along the top edge of your pocket, approx. 1cm (3/8") apart.
7) Pin the pocket piece to the front of your apron in the position shown. Topstitch
close to the folded edge - down the sides, across the corners and along the bottom.
Reinforce the top of each side with an X shape, if desired. Repeat with a second row
of topstitching 1cm (3/8") in from the first line of stitching, so that your raw edges
are enclosed and not visible inside the pocket.
8) Lay your front and lining fabrics together right sides facing.
9) Cut two lengths of twill tape each approx. 80cm (32") long - these are the straps
that will tie around your waist. Cut another length of twill tape approximately 25cm
(10") long. This length will form part of the adjustable neck strap.
10) Take one raw end from each cut length of twill tape and hem it by folding it over
twice (about 5mm or 1/6"). Stitch across several times.
11) Cut another length of twill tape to 40cm (16") long. This length will form the
other part of the adjustable neck strap. Thread the two D rings onto one end of the
tape and make a small loop to enclose them. Tuck the raw end in and stitch across
several times.
12) In the positions shown on the pattern, pin all the neck and waist straps between
the two layers of fabric, each with the unfinished end poking out and the length of
strap coiled in between the layers. Make sure the neater side of your D-ring loop is
facing the front fabric. Also, make sure the straps don't get in the way of any stitching
you’re about to do! Pin them out of the way if need be.
13) Starting midway along the bottom of your apron, sew around the edge with a 1cm
(3/8") seam allowance. Whenever you stitch across one of the straps, double back and
forth over it to provide extra reinforcement. Continue around the edge until about
20cm (8") away from your starting position.
14) Trim excess fabric away at the corners, and at any curves.
15) Through the 20cm (8") hole in the bottom edge, turn your apron right side out.
All your loops and straps will be revealed.
16) Push all the edges and corners out. Along the bottom tuck the raw edges of your
fabric back into the hole so you have a straight bottom edge. Press it all flat!
17) To finish, topstitch around the whole apron about 5mm (1/6") in from the edge.
Thread the shorter neck strap through both rings from back to front, and then back
down through the bottom ring.