How to factory default AV Tech “Eagle Eyes” DVR

How to factory default AV Tech “Eagle Eyes” DVR
For Model(s): VC-SYS-4WEBMVPB
V 1.1
By AGI Security Technical Department
Step 1:
Remove the DVR cover and locate the main board. Locate the jumper pinholes as incicated by the yellow
arrow as shown bellow in figure 1.
Figure 1
How to factory default AV Tech DVR
1
Step 2:
TP5 and TP6 are the pinholes you are looking for. As seen bellow in figure 2.
Figure 2
Step 3:
Disconnect power to the DVR. Next you will need to make the chip resistor short-circuited with a
conductive object. While shorting the resister, re-connect the power. See figure 3 bellow.
Note: You can use any metal tool or object that can conduct current so you can short-circuit the resister.
Remove the conductive object when you hear a short beep sound, and wait till the DVR reboots.
How to factory default AV Tech DVR
2
Figure 3
Your DVR should now be defaulted to factory specifications. You will not lose any recorded data on your
hard drive. Only the DVR settings will be reset to default. If you have any trouble with this, please
contact Leadertech / AGI Security Technical Support.
How to factory default AV Tech DVR
3