BOSCH Sample paper The selection process consists of 3 rounds.

Transcription

BOSCH Sample paper The selection process consists of 3 rounds.
Bosch
www.futurepathfinder.com
BOSCH Sample paper
The selection process consists of 3 rounds.
1)
Written test.
2)
Technical Interview
3)
HR interview.
Duration of Test: 60 min
Number of questions: 60
Number of sections: 3
No of questions in section 1: 35 (Technical)
No of questions in section 2: 15 (Aptitude)
No of questions in section 2: 10 (General English)
NOTE:BEWARE OF NEGATIVE MARKING…
Section1: Technical
1. Forces lying in the same plane but never met
Ans.parallel
2. Ger ratio for helical gears one of 30 tooth and the other 60 tooth
a)800:1 b)2:1
3.
If u traveled 45 min at 4 miles per hr and 30 min at 3 miles per hr. what is the distance
covered by u in 1 hr and 15 min.
Ans.6miles
4. A ball of weight 10N is dropped freely from rest at a height of 4 mts.what is its total
mechanical energy after it has traveled 1 meter.
5. Two bodies of same mass r traveling at a velocity of 2 m/sec in opposite direction.
After collision one travelled with 1.8 m/sec what abt the other..
a) equal to 1.8 m/sec b)more than 1.8
c) Less then 1.8 d) can not say
6. If X-component of a force is –Ve and Y-component is +Ve, in which plane the
Resultant would be ans:a
a) First quadrant b) second c) third d) fourth
7. A body is said 2 b in equilibrium
Ans:c
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.
Bosch
www.futurepathfinder.com
a) if it is in rest b)if it is I uniform velocity
c) if the sum of the forces acting on it is zero d)none
8. A chain of leanth 1 mt and mass 1 kg is placed on a table.What leanth of the chain
must be hanged freely from the table so that is will drag the remaining chein
freely. Ans (d)
a).55 b).66 c) 0.5 d).75
9. Main purpose of governer
Ans.(d)
a) to live happy life b) to increase engine speed
c) to decrease engine speed d)to run engine smoothly
10. .A steel beam of mass m and length l is placed on a surface.a couple u is applied at
the ends to rotate the beam at 90 0 . what is the work done.
11. A & B r two weight lifters .A can lift 100 pounds 10 times a minute, where as b
lifts 100 pounds 10 times a sec.who is doing more power and work.
a)A&B b)A omly c) B only d) none.
Ans(c)
12. A ship is 77 Km away from the shore.It had a leak due to ehich water is flowing
into the ship @ 1 ton /min .A pump is used to pump the water out of the ship @
30 ton/ hr The ship sinks if the water Qty reaches 210 ton.what should b the
speed of the ship to reach the shore b4 it sinks. Ans:b
a)7 mph b)11mph c)15 d)20
13. Find the hypotenuse of the side given:
Sides 8, 11
14. The angle of depression from the top a building to another building is 120 .the
distance b/n the two is 50 mts.What is the difference in the height of buildings.
a) 10.6 b)20.3 c)10.4 d)48.9
15. Which is the largest side in a right angled triangle
a) hypotenuse b)edgescent side c)opposite side
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.
Bosch
www.futurepathfinder.com
16. Two force acting along the same line but in the opposite directions. they r called
a) Concurrent b) coplanar c) collinear d) non concurrent
17. Two basic systems of forces Ans:(c)
a) Coplanar, concurrent b)non concurrent, concurrent
c) Coplanar, non coplanar d)concurrent , non coplanar
18. . Formula for power in HP
19. X15-X13+ X11-X9+X7-X5+X3-X=7 than value of X16 ?
20. Simplyfy [ 3v--- 27 - v—(27/4)]2
21. When compared to spur gears bevel gears r more
a) noisy b)smooth
Ans:a
22. 26. The angle b/n bore axis of gear and the tangent to the teeth profile is called
Ans: helix
23. If a body is isolate from it’s mating parts and all forces acting on it r shown then it
is called.
Ans (c)
a)BM diagram b) SF diagram c)free body diagram d)none
24. The circle touching the outer edge of the teeth is called
Ans: (c)
a) Base circle..b) pitch crcl c) addendum crcl d)….
25. 28. The area of the piston A is 10 cm2 and that of B is 4 cm 2 .If 10n load is applied
on the piston A what is the force on the piston B.
Ans: (c)
a)100N b)40N c)10N d)none
26. Belt drives r mainly used for
Ans: c
a)to reverse the direction of power in belts. b)to transmit it power.
c) all
27. BS thread profile has
a)141/2 0 b)450 c)250 d) 90 0
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.
Bosch
www.futurepathfinder.com
28. The main purpose of bearings
Ans:b
a)to reduse noise. b)to reduce friction
29. . A coin and a ring of same mass and diameter r allowed to roll smoothly from the
top of a inclined plane. which one reaches the bottom first.
a)coin b) ring c)both reaches same time d) none
30. A ball is thrown horizontally .After hitting the ground it again raises with some velocity.this
is because
Ans:b
a)ball is stil having velocity b)it gains momentum from the ground
31. The force exerted by a spring depends on Ans:(d)
a)Material of the spring b)Design of the spring c)Length of the spring d)all
32. volume of water per cubic metre of air.
(a)specific volume
(b) specific gravity
(c) vapour pressure
(d) none of above
33. Maximum degree of freedom in space
Ans:6(Not sure)
34. Which can,t be removed during alloying from Fe alloys
a) co
b) N
c) Si
d) As
35. Critical stress at which material will start to flow
(a)yield
(b)ultimate tensile stress
(c) proof stress
(d) none o the above
Section2: Aptitude
1. A and B starts moving from points X and Y simultaneously at a speed of 5kmph and 7kmph to a
destination point which is of 22km from points X and Y. B reaches Y earlier than A and
immediately turns back and met Z. Find the distance XZ.
2. Ann is shorter than Jill and Jill is taller than Tom. Which of the following inferences are true?
a) Ann is taller than Tom b) c) d) Data insufficient
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.
Bosch
www.futurepathfinder.com
3. Sum of squares of two numbers is 404 and sum of two numbers is 22.Then product of two
Numbers?
a) 20 b) 40 c) d) (Answer is 40. Two numbers are 20 and 2)
4. X and Y starts from same point at opposite direction. They will move 6km and take 8km left.
How Far is A and B from each other?
5. In an examination 4 marks are assigned for correct answer and 1 mark is deducted for wrong
answer. However one student attempted all 60 questions and scored 130.Number of questions
he attempted correct is?
a) 35 b) 42 c)None of these
6. Each ruby is of 0.3 kg and diamond is of 0.4 kg.Ruby costs 400 crores and diamond costs 500
crores.Ruby and diamonds have to be put into a bag. Bag cannot contain more than 12 kg.Which
of the following gives maximum profit (or in terms of wealth) (In crores)
7. A man sells an article with a 20% discount and gain a profit of 20%...what would be the profit
percentage if he sells it with 10% discount...?
8. Fourth term of an ap is 200 and first term is 5 find the tenth term?
9. If 25% of x=y then 62.5% of x in terms of y is:
(2.5*y)
Check it
10. If x+2y=220 and x=80 then y=
Ans:70
11. A student was performing an arithmetic operation and he multiplied a number by 7/5 instead of
dividing it by 5/7 what was its error percentage?
Ans: No error
12. If side of the square is x+2 and side of equilateral triangle is 2x and the perimeters of both
square and equilateral triangle are equal ...then find the value of x is ?
A)2
B)4
C)6
D)8
Ans:B
13. if side of the square of increased by 5 and change in area was 165 then find the value of side of
the square?
Ans:14
14. The length of a side of a square is 2 the length of equilateral trianlge is 2x if the square and the
trianlge have equal parameter find the value of x?(Very simple one)
15. It takes mr. Kartik x hrs to complete a manuscript after 2 hrs. He cold away what fraction of the
assignmnet was left incomplete?
A-(x-2)/x, B- (x-1)/x,C- (x-3)/x,D- (x-5)/x
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.
Bosch
www.futurepathfinder.com
Section3: General English
Find appropriate meaning in ques 1-4
1. Go for …………. Ans: a
a) Try b) Get it c)Quit
2. Go overboard…………….. Ans :a
a)exaggerated b) exagerate c) exagratred d) none
3. Go Wrong……. Ans: b
a)Fail b) Mistake
4. Meaning of batten …..
Ans : noun : a long wood of metal strip
5. The plural of Virus is
a. Viruses
b. Virae
c. Virii
d. Virus
6. People living in glass houses..
a) may not throw stones
b)didn’t throw stones
c) cannot throw stones
d)should not throw stones
7. . If leaf is to leaves and knife is to knives, then belief is to –
a. beliefs
b. believes
c. belief
d. believing
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.
Bosch
www.futurepathfinder.com
8. When the fire alarm rang _______ left the building immediately
a. all
b. everyone
c. all the people
d. every person
Directions for Questions 9 And 10: one of the four sentences given in each
question is grammatically wrong . Find the incorrect sentence
9. The roll (A)/of the institute is to provide technical support to other institutions and to
constantly monitor (B)/their facilities(C)/and performance.(D)/No error(E)
10. I did not like his (A)/comments on my paper(B)/but I had no alternative(C)/as I had
agreed to keep quiet.(D)/No error(E)
Disclaimer: All the matters in this document is true to our knowledge. And we are not responsible
for any mistake and misprint in document.