Short Manual Machine B RRT dw 2014

Manual Machine B
Short Manual Machine B

















RRT dw 2014
Machine parameters
Rinse aid setting 3
Programme setting RRT programme
Reference detergent dosage 5 g in compartment I & 25 g in compartment
II
Power management system  the duration until the appliance switches
off automatically shall be determined (Left-on-mode duration)
Programme setting
Load the machine
Fill in the detergent and close the door.
Switch on the main switch (the start indicator light flashes and the
indicator light shows the selected programme).
Select the programme (RRT programme) with the selector button V. The
duration of the cleaning cycle will be shown.
Do not select any additional options.
Press start.
Setting of the rinse aid dosage
Switch the dishwasher off with the Φ button, if it is switched on.
Press the Start button in and whilst holding it in switch the dishwasher on
using the Φ button.
Keep the Start button pressed in for at least four seconds until the Start
indicator light comes on. If this does not happen, start the procedure
from the beginning again.
Press the
button 3 times.
The indicator will flash rapidly 3 times at intervals.
The value set for the dosage is shown flashing after “P” in the display.
If it is not P3: Use the Start button to select the value 3. Each press on
the button moves you up a level. When the highest rinse aid level (6) is
reached, the setting starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the Φ button.
 Rinse aid should be refilled at the beginning of the test runs in each
laboratory. The reservoir is located in the door. Press the button on the lid
in until the flap springs open to fill the reservoir. Add rinse aid only until it
is visible in the opening.
Manual Machine B







Setting of the water hardness
RRT dw 2014
Switch the dishwasher off with the Φ button,
if it is switched on.
Press the Start button in and whilst holding it
in switch the dishwasher on using the Φ On button
Keep the Start button pressed in for at least four seconds until the Start
indicator light comes on. If this does not happen, start the procedure
from the beginning again.
Press the
button twice.
The
indicator will flash rapidly twice at intervals.
The value set for the water hardness is shown flashing after “P” in the
display.
 The adjustment P14 is for water of 14 °dh or 2,5+/- 0,5 mmol/L.
If it is not P14: Use the Start button to select the value which equates to
your waterhardness level. Each press on the button moves you up a level.
When the highest water hardness level is reached, the setting starts from
the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the Φ button.
 Salt should be refilled at the beginning of the test runs in each
laboratory. The salt tank is located at the inner bottom of the machine.
Remove the lower basket and unscrew the salt reservoir cap to fill the
reservoir with the funnel provided.
Manual Machine B
Machine Overview
RRT dw 2014
Manual Machine B
Loading scheme (12 place settings)
RRT dw 2014
 Upper basket
Upper basket level: Middle, Jumbo-cup rack: widest setting
 Lower Basket
Manual Machine B
RRT dw 2014
Loading scheme (12 place settings)
 Cutlery insert
Before loading cutlery remove the side sections (see illustration) and fit
the insert supplied into the cutlery basket.