Document

SMART LIGHT
IN THE BOX
+ Smart Light
+ Smart Light Holder
+ Elastic Phone Holder
+ DC Cable (1m)
+ Dynamo
+ Dynamo Holder
+ Cable Holders
TOOLS NEEDED
+ Pliers (2x) or Wrench (2x)
+ Screwdriver
INSTRUCTIONS FOR USE
Using the Smart Light
1. DC connector to charge the Smart Light.
2. Button to turn the LED light on or off.
3. USB connector to charge the phone or any device that
can be charged with a USB cable.
1
2
3
Charging the Smart Light
You can charge your Smart Light in two ways:
1.Charge while riding. Engage the dynamo by pressing it
downwards to put it in contact with the tire.
2.Charge at home. Connect the Smart Light to a compatible
cable and plug into a socket.
CAUTION! Never charge the Smart Light via USB connector
on the Smart Light.
Removing the Smart Light
•Press the switch positioned at the back of the Smart
Light Holder and gently slide Smart Light out.
CAUTION! The Smart Light is water resistant but not water
proof.
INSTALLATION
1
Installing the Dynamo
•Attach the dynamo to the front fork of your bicycle. The
longer part should be faced outwards.
•Insert the screws into the hole and tighten it loosely.
•Find the desired position for the dynamo and tighten all the
screws.
CAUTION! Make sure the dynamo is secured tightly.
2
Connect the Cable
•Attach the two wires to the dynamo by pressing down
the dynamo cabel’s holders and insert the wire.
3
Positioning the Smart Light Holder
•Place the Smart Light Holder onto the steering wheel.
•Insert the screw into the Smart Light Holder from the
bottom up and tighten it.
•The screw should be in front of the steering wheel.
NOTE! If your steering wheel is too small, wedges must be
added, to ensure the Smart Light Holder is secured tightly.
4
Attaching the Smart Light
•Attach the Elastic Phone Holder on the Smart Light.
•Place the Smart Light onto the Smart Light Holder, by
gently sliding it into the ridges of the holder.
CAUTION! Make sure the Smart Light is tightly secured
onto the Smart Light Holder.
5
Attach the Cable
•Attach the cable to your bicycle with the help of the Cable
Holders.
•Connect the dynamo and the Smart Light.
CAUTION! Be careful not to over-tighten the cable, as that
may prevent you from freely using the steering wheel.
6
Positioning the Phone
•Place your phone either horizontally or vertically onto
the Smart Light and secure it tightly with the help of the
Elastic Phone Holder.
WARRANTY
FlyKly Smart Light comes with one year warranty
including the battery, electronics and LED light.
For additional information go to
www.flykly.com/legal
SUPPORT
For support please contact us at
[email protected]
© 2014 FlyKly, Inc.