Powder Vibe - Diamond Tech

SKU# 802000
SKU# 802002
Powder Vibe
The Powder Vibe is a quick and mess-free way to precisely dispense frits or
enamels onto any surface for enameling, fusing and lampworking projects.
1. Separate the barrel of the Powder Vibe and insert two “AAA” batteries,
positive side-down into the barrel. Slide the barrel sections back together.
2. Remove the Powder Vibe tip from the barrel, place a finger or tape over the
hole in the tip and spoon your choice of powder frit or enamels into the tip.
Slide the tip barrel back together.
3. Place the tip on the Powder Vibe, connecting them at the magnetic
connection point.
4. To use, hold the Powder Vibe like you would hold a pen, with the barrel
resting between your thumb and index finger.
5. Use your index finger to apply pressure to either the right or left side of the
Pressure Switch to activate and release frit/enamels from the Powder Vibe unit.
TIPS:
• Don’t let the tip of the Powder Vibe touch the surface as the vibrations will
cause a disruption in the pattern/design.
• To create continuous lines, hold down on the switch until you are done.
• To create dot, press down on the switch intermittently.
• If you enjoy using multiple colors, an extra tip set may come in handy.
• When changing out colors, use a cotton swab to clean tip and cap. Never
blow directly into the tip and cap as it may cause moisture buildup resulting in
corrosion.
WARNING! This tool contains magnets or magnetic components. Magnets
sticking together or becoming attached to a metallic object inside the
human body can cause serious or fatal injury. Seek immediate medical
help if magnets are swallowed or inhaled.
KEEP OUT OF REACH OF CHILDREN!
Remove batteries when not in use.
Manufactured and Distributed by Diamond Tech
Tampa, FL 33634 | www.DiamondTechCrafts.com | 1.800.937.9593
Made in USA