Delightful Drops Wrap Bracelet - Off the Beaded Path Home Page

Off the Beaded Path
Delightful Drops Wrap Bracelet
By: Kelly Dale of Off the Beaded Path
April 2015
Materials List:
*26 inches of .018 49 Strand Beading Wire
*100 Top Drilled Tear Drop Beads
*30 11/0 Seed Beads
*98 8/0 Seed Beads
*(2) 2x2mm Crimp Tubes
*12mm Button
*Crimp Pliers & Cutters
*Please read this entire pattern before beginning the project.
*I used a 12mm Swarovski Button but you can use any button that
you may have on hand, you will just have to adjust the seed bead
loop.
*I used tear drops for this project but you can use any beads to make
this wrap bracelet.
1. On your beading wire thread on one tear
drop and one 8/0 repeatedly until you have
all beads added.
2. At the very end of your wire thread on one
crimp tube and 24 11/0’s. Go back down
through the crimp tube and using your crimp
pliers, crimp the crimp tube. Trim the short
tail.
3. Let all beads fall down to the finished end.
Check the fit on the bracelet and add or
remove beads as needed.
4. On the unfished end of the bracelet thread
on a crimp tube, three 11/0’s the button, and
three 11/0’s. Go back down through the
www.offthebeadedpath.net
www.offthebeadedpathbeadstore.com
crimp tube and pull the wire so that everything pulls down to the last drop added.
5. Using your crimp pliers crimp the crimp tube and trim the short wire.
www.offthebeadedpath.net
www.offthebeadedpathbeadstore.com