Universal Crimp Tool

ASI
Universal Crimp Tool
Automation Systems Interconnect, Inc
Innovative Interconnect and Interface Solutions
CRIMPER WITH INTERCHANGEABLE CRIMP DIE
Tool designed for use by the installer. The crimp dies move parallel to each
other and generate a force of 10,000 N. The entire tool is covered with a
plastic shell that makes it ergonomic and comfortable to use.
Crimp Die
Crimp Die
Retainer
Lever
Handgrip
TYPE CAT. NO. DESCRIPTION
UMCT
UMCT3149
Crimper with interchangeable crimp die
(does not include crimp die -- select and order the
matrix according to use)
TYPE CAT. NO. DESCRIPTION
UMPU02510
UMCT3127
Crimp die for ferrules from 22-8 AWG
UMPU1625
UMCT3153
Crimp die for ferrules from 6-4 AWG
UMPU3550
UMCT3154
Crimp die for ferrules from 2-1/0 AWG
UMPI1525
UMCT3129
Crimp die for ring and spade terminals from 16-14 AWG
UMPI4060
UMCT3128
Crimp die for ring and spade terminals from 12-10 AWG
IS3152
IS3152
Crimp die for Solarlok photovoltaic connectors (R)
Tyco Electronics
IS3153 IS3153
Crimp die for Solar Line 3 photovoltaic connectors
IS3154 IS3154
Crimp die for Solar Line 4 photovoltaic connectors
Crimp dies UCMT 3127, UCMT 3153, and UCMT 3154 can crimp 12 mm long eyelets with a
single compression. For longer eyelets, a second crimp is sufficient. (These crimp dies do not
have a positioner and do not limit the length of the eyelet).
HOW TO REPLACE CRIMP DIES
•Open the pliers as wide as possible (fig.1);
•Slowly bring the two levers of the pliers together,
until the locking/release mechanism makes three
clicks (fig. 2);
•Observe the anchorage pin on the crimp die (fig. 2);
•Insert the crimp die, moving the anchorage pin
towards the internal part of the pliers chamber (fig.3);
•Make sure that the plastic tooth has locked the
crimp die in place or that it has risen (fig.4);
•Press the two levers of the pliers, closing them as
tightly as possible (fig.4);
•Release the handles; the pliers should open
automatically and completely (fig.5);
•If, when the pliers are closing, you realise that
the crimping is not successful or the crimper
is blocked for any reason, pressure can be
released by pressing and releasing the handles a
few times and simultaneously pressing with your
thumb on the release lever on the internal part of
the handle (fig.6).
Automation Systems Interconnect, Inc.
www.asi-ez.com
n
P.O. Box 1340, Mechanicsburg, PA 17055
n
Phone: (717) 249-5581 or (877) 650-5160