Ways of working with acrylic

Transcription

Ways of working with acrylic
Ways of working with acrylic
Working with acrylic involves doing a lot of things such as cutting, drilling, polishing and
gluing. If you do not know how to go about it, then you will not get the best end result.You have
to get it right if you want to succeed when using the acrylic. There are numerous ways in which
you can work with acrylic. Here are just some of the ways you can work with acrylic to get the
best result.
Flame polishing
One of the ways that you can work with acrylic is by flame polishing it. In case you cut a piece of
clear acrylic but it still looks frosty, you can flam polish it to give it a clearer look. It will not
easy at first and you have to keep practicing. You can melt the edges by simply brushing the
flame. It will give them a polished appearance.The only thing you have to do is make sure that to
only polish areas that you want to glue.By doing so, you will
avoid stress of sticking surfaces that you did not want to glue.
Cutting
You can use plastic scoring blade to make straight cut in your
gold acrylic mirror. Make sure that the blade is facing towards
you and leave a score guide. You should score the acrylic a
number of times on the same line. Once you are done, you should place your acrylic on the table
and snap the pieces into two. There are also other ways that you can use to cut acrylic using
tools like table saw, band saw and jigsaw. The tools have high tooth count cutting blade. These
blades are recommended for cuttingsilver acrylic mirror.
Gluing
Solvent based glues are the most popular in gluing opal acrylic tubing.Gluing the material will
soften it and bonds the two pieces together.If you want to glue using solvent glue, then all you
have to do is just squeeze the bottle and apply it on the edge of the acrylic.Put the glue where the
two pieces meet. You can also squeeze the applicator lightly and pull the pieces towards you.You
can also join the pieces using capillary action. All you have to do is just make sure that you pay
attention when gluing to avoid any unnecessary mistakes.
Drilling
Drilling is one of the ways to use acrylic. Drilling acrylic with wood drill bit, you will only crack
it. In case it is a thin sheet, you need to use a step drill.If you are working on a thick piece, then
you can use conventional drill bits.
These are the ways you can work with the high impact acrylic. Using it the proper way will no
doubt get the best results. Whether you want to drill, glue,and polish or cut your acrylic rod, you
do not have anything to worry about. All you have to do is just follow the procedure for working
with acrylic and you are good to go.
P&M Plastics
12 Township Drive, Gold Coast, Queensland
07 55357544
leon@pmplastics
http://www.pmplastics.com.au/