Geyer Hosaja DOBRO puzzle mats installation manual

Installation manual
Rubber mats for walking areas,
milking parlours and waiting areas.
Requirements for installation: beton I asfalt
DURING THE INSTALLATION THE FOLLOWING INSTRUCTIONS SHOULD BE STRICTLY FOLLOWED.
• Optimal temperature for
installation 5-30 °C
• Store before
installation for 2-3 days in
temp. approximately 15 °C
Concrete min 10 cm
Use scraper System
adapted to Rubber floors according
to manufacturer.
Laying out and connecting the mats.
Fig. 1. The general principle of connecting the mats with
the „puzzle“ type connectors,
Fig. 2.1 Laying out and connecting the mats on the
walking ways.
Fig. 2.2 All options of connecting the mats are possible depending on the shape and size of floor surface
Asphalt min 3 cm
Concrete min 10 cm
Concrete must be clean and flat
Fig. 1
Attention!
Do Not press the mats together
Put the mats loosely
Rubber mat
The mats should be laid out on the floor and connected
with the „puzzle“ type locks. leaving about. 2 cm of space
from the walls and other restrictions of floor surface - Fig.
3.1 and 1 cm from the scraper guiding rail - Fig. 3.2
Fig. 2.1 Laying out and connecting the mats
Fig. 3.1
OK
Scraper guiding rail
Fixings
Fig. 2.2
Rubber mat
Cubicles / Feeding area
Fig. 3.2
„Geyer & Hosaja Sp. Z.o.o. Edition 2011 r.
39-310 Radomyśl Wielki, Partyia 12
Installation manual
Rubber mats for walking areas,
milking parlours and waiting areas.
Fig. 3 Adjusting the mats
Adjusting the mat to the expected shape and attaching it to the
concrete base.
The mat can be cut to the required size and shape, the parts of
the „puzzle“ locks „ can be cut as well, - if the mat is adjacent to
the wall or other space restriction
of the floors of cowsheds - Fig. 3
In order to protect the mats against their possible
disconnection during use - e.g.; by the moving collector
of animal faeces or by a tractor used in the cowshed the mats should be additionally attached to a concrete
base in the manner presented in Fig. 4
Fig. 4 Attaching the mats to the ground
crew
2mm
Fig. 4B
Fig. 4C
Fig. 4D
shim
Rubber mat
It is possible to drive through the
mat on conditions:
• no abrupt steering actions, do
not steer while standing still
• slow accelaration and gentle
braking
Heavy vehicles may have negative
impact on the mats. If necessary
locks should be corrected.
„Geyer & Hosaja Sp. Z.o.o. Edition 2011 r.
39-310 Radomyśl Wielki, Partyia 12
Animal - friendly screw head
x
x = min 70 mm for regular concate floor
x = min 120 mm for asphalt floor
y = min 6mm
y