Wall Mount Tension Frame and Covers

C O M M E R C I A L
E X T R U S I O N S
Wall Mount Tension Frame and Covers
Part
Number
Part
Length
Finish
2090
2088
2089
2091
Wall Mount Tension Frame
Wall Mount Tension Frame Square Cover
Wall Mount Tension Frame Radius Cover
Wall Mount Tension Frame Beveled Cover
24’-5”
24’-5”
24’-5”
24’-5”
Mill Finish
Mill Finish
Mill Finish
Mill Finish
1”
1.16”
1-1/2”
Part #2090
1”
1”
1-1/2”
Part #2089
1-1/2”
Part #2088
Part #2091
Features & Benefits
4.11”
·
Low profile
system that will tension any size flexible face
or banner material.
·
Fully secured covers with recommended fasteners.
(NOTE: Attach as recommended).
·
All covers completely conceal
Cover Screw
Part # 5215
the Wall Mount Tension
Frame edges.
·
Allows for conformity when mounting to walls with
irregularities.
·
Eliminates hemming, grommets, and double-faced tape.
·
Affordable, easy to use, and re-usable.
#8 x 3/4" Square drive pan head screw
Wall Mount
Tension Frame
Radius Cover
Part # 2089
Corner Key
Part # 5210
Tension Clip
Part # 5360
Wall Mount Tension Frame
Part # 2090
Flexible Face Material
3032 Walker Ridge Dr. NW
Grand Rapids, MI
Phone: (616) 784-0405
Toll Free: (877) 784-0405
Fax: (616) 784-0411
Wall Mount Tension Frame - Part #2090
Wall Mount Tension Frame Radius Cover - Part #2089
Kit Designation - K2090/89
Note: Pressure fit
Do not over tighten.
1”
Note: Drill 1/8” pilot hole.
Drill through the first leg
of the cover only.
1-1/2”
FAQ
2090/89
Features & Benefits
The Wall Mount Tension Frame will tension any
size flexible face or banner material and only
projects 1” off of the attached support structure.
The Tension Clips are easy to use and are re-useable.
Eliminates hemming, grommets and double faced
tape.
Answers to FAQ’s
h
Accepts any flexible face material.
h
Face material trim size - Add 2-1/4” of fabric to all
4-1/8”
See page 13, 15 & 39 in the
Gold Commercial Catalog
for more details.
Without Frame
four sides (adding a total of 4-1/2” to both the
height and width) to establish the trimmed edge
of the fabric.
h
Tension Clip placement - Tension Clips are placed
approximately 2-1/4” from the edge of the
trimmed to size face material.
h
Tension Clip spacing - Every 6” on center.
h
Visible opening - 3” less than the overall frame
height and width.
h
The Reverse Wall Mount Tension Tool, Part #5138
and the Wall Mount Tension Tool, Part #5137 are
designed to tension this frame.
With Frame
For further assistance please contact SignComp Customer Service
Toll Free (877) 784-0405 Phone (616) 784-0405 Fax (616) 784-0411 [email protected] www.signcomp.com