Build a GameBoy Color programming cartridge with MBC5 chip and
Transcription
Build a GameBoy Color programming cartridge with MBC5 chip and
Build a GameBoy Color programming cartridge with MBC5 chip and AM29F032B-90SD flash chip. © 2008 by Reiner Ziegler First, buy a cartridge with ROM+MBC5+RAM+BAT. For more details about MBC5 cartridges take a look into http://www.reinerziegler.de/gbcmbc.txt. I bought a Zelda cartridge with 32K RAM. With this large RAM you can play nearly all GBC games. Second, buy the 29F032B-90SD flash chip from www.spoerle.com or from www.jameco.com. Remove the ROM chip (MX23C8005) carefully with a sharp cutter. 40-Pin TSOP package 44-Pin package 32-Pin package 44-Pin SO package AM29F032BSEC LH538 ROM AM29F032BxxEx (x = KM23C16120 / Macronix xxSD (x = don't care) ROM MX23C8005 don't care) Pin 1 After that, solder 5 cm wires on each pin, except pin 5, 6, 7, 8. Cover all pin’s (except pin 5, 6, 7, 8) with a piece of tape and solder the AM29F032B-90SD with pin 7, 8, 9, 10 directly to these 4 pin’s. Pin 1 2 3 4 5 6 7 8 9 10 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 37 38 39 40 Pin 2 3 34 35 36 37 38 39 12 23 Cart Pin 30 40 41 42 4 5 6 7 8 9 10 11 31 15 17 19 21 13 32 23 24 26 28 30 14 Cart Pin 3 44 43 Pin 1 31 30 2 3 29 28 4 22 32 Cart Pin 30 25 23 26 27 5 6 7 8 9 10 11 12 13 14 15 17 16 16 32 18 19 20 21 24 Cart Pin 3 MBC5-RA21 MBC5-RA20 Pin table for ROM chips and FLASH chips Cart Pin 3 = /WR = WE# Cart Pin 30 = /RESET = MBC5-/RESET The tape is necessary to avoid any short between the PCB pin’s and the flash chip. Pin 35 36 37 38 39 40 41 42 43 23 2 3 4 5 6 7 8 9 10 13 14 15 16 17 18 19 20 21 22 44 24 25 26 27 29 30 31 32 remove old chip MX23C8005 add new AM29F032B-90SD flash memory chip Connect the AM29F032B-90SD pin’s to the corresponding pin’s described inside the pin table for ROM chips and FLASH chips. Try not to cross to much wires over the flash chip, there is not enough place for doing that. Try to use thin wires. I always use wrap wires for this kind of modifications. You will need 3-4 hours for building this cartridge and a very thin soldering equipment. Good luck ☺ Reiner Ziegler www.reinerziegler.de