Setup Instructions Here

20x40 Foot
Pagoda
Commercial Party Tent
20x40 Foot PVC Pagoda INSTRUCTION
ARTS NO.
Reference image
Qty
1
2
2
1
3
4
4
2
5
6
6
6
7
2
8
14
9
4
10
52
10
32
11
12
12
2
13
18
14
1
Spiral peg
4
screw
4
Bolt+nut
152
bungeeball
160
rope
4
roof
1
Panel
6
Assemble Manual
STEP 1
Select a flat ground for the tent, unpack the carton and check all the parts including tubes,
tent and accessories… etc. are present as same as list.
Assemble the framework of rooftop by joining the portion (1.2.3.4.5.6) together with poles
(10.11.12.).To ensure the screw fixed to every pole tightly
Step 2
Place the roof onto the frame and use the bungees to fasten it. Be sure not to put too much
tension on the bungees in order not to make attaching the other side more difficult.
STEP 3
Lift up all legs.
STEP 4
Attached all groundbar at the bottom of the frame as below image.
STEP 4
Hang walls. Attach it by the bungee balls properly.
Warning:
1. In order to avoid being rusted by air, oil is covered on the surface of the pipes ,before set
up the tent ,please remove the oil carefully first to keep the cover clean.
2. Take note that the tent needs to be handled carefully to avoid damage.
3. Do not force the frame as they may be damage in the process.
4. Tents are meant as temporary shelter and must be evacuated under extreme weather
conditions.
5. The windows maybe a little bit sticky to each other, when you unfold the windows, please
do as softly as you can .Or the windows maybe crack during the process.
Please select a suitable site for the tent to avoid the damage to underground sprinkler
systems, water, gas or electrical lines.