wannabe - Moda Light

WANNABE®
I N S T A L L A T I O N
1
Verify electrical plan.
Rotate fixture to expose screw holes.
Make sure to use all four screw holes
when mounting.
2
3
Ensure Power is Off!
L
S
L
N
R
100-240v AC
N
Junction Box
Not Included
Optional: Reverse Phase
ELV-Type Dimmers only
10’ Wannabe® Leader Cable
4
Optional 1’
Wannabe® Jumper Cable
5
#1
Check which model you have:
100-240v AC 50/60Hz
277v AC 60Hz
100-277v AC 50/60Hz
#2
.....
Max Run Lengths: 100pcs 120v, 230pcs 277v
#229
#230
End Cap Must be Placed on Last Fixture
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED. CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE
PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS.
All MODA LIGHT products should be installed by a Licensed Electrician to local & national code. Do not modify, adapt or cut any MODA LIGHT components, plugs or accessories. Any modifications will void the warranty
and may create a potential safety hazard. Do not put on the same circuit as inductive loads. Incorrect wiring will result in irreparable permanent damage to the LEDs and fixture. MODA LIGHT tests all products before
shipping, and will not replace items that have been destroyed by incorrect wiring or handling. Ensure electrical circuit is switched off before wiring. See MODA LIGHT terms and conditions for product limited warranty.
© Cop yrig ht 2 01 6 • 955 W hit e Dr iv e, Las Vega s , N V 8 9 11 9 • T: 7 0 2 4 0 7 7 7 7 5 • F : 7 0 2 4 0 7 7 7 7 3 • w w w.m o d a l i g h t.co m
VDC2016303