self explanatory instructions for the assembly of avro arrow model

 SELF EXPLANATORY INSTRUCTIONS FOR THE ASSEMBLY OF AVRO ARROW MODEL FROM ESING These serve also as a guide for all delta ESING models such as: Arrow, Concord, Cutlass, F­102, Draken, Kfir, Me­163, Lavi, Pogo, Vulcan, Mirage, Eurofighter, etc. NOTE: In case you ask yourself, “marco” means frame NOTE: Only upper parts have identifying circles NOTE: Use very sharp cutters and scissors NOTE: Identify in the backing like URW for upper right wing. ULW for upper low wing, LRW for lower right wing, LLW for lower left wing, UF for upper fuselage and LF for lower fuselage. NOTE: In this case we are using foamboard, but you can use Depron, Coroplast or Balsa sheet NOTE: Start with the upper sides, where the little circles appear NOTE: You have to be extremely careful in handling the peeled vinyl, If it sticks to itself, you are in trouble. NOTE: Better cuts are made with several light passes VERY IMPORTANT: Vinyl is a difficult material to glue, this liquid silicone along with UHU cement are suitable, that is why is also necessary to sand the glue lines. NOTE: We highly recommend two more beads of cement at the joining angles. NOTE: This is how we recommend servo installation: easy, neat and effective NOTE: This model as is has the next configuration Wing area: 250 sq in (1.74 sq ft) Span: 23 in Weight: 17 oz (1+ lb) Motor: Brushless inrunner 100 watts Prop: 7x4 Wing loading: 9 oz/sq ft. BUT WHAT IF AN ACCIDENT HAPPENS, HOW TO REBUILD IT? NOT EASY BUT SAME JOB AS REBUILDING OTHER KIND OF MODELS NOTE: Hardware may depend on your preferences: Pusher outrunner Pusher inrunner Mid fuselage ducted fan Power slope soaring We have given you these hints, but in the end is your experience what counts. CONGRATULATIONS, you just finished a model to show off. [email protected] http://www.radiocontrolesing.com