PowerMadd Sentinel handguard mounting on Polaris IQ chassis

PowerMadd Sentinel handguard mounting on Polaris IQ chassis
using 34450 Sentinel Snowmobile mount kit
Use these instructions along with the instructions provided with the 34450 mount kit.
On the IQ chassis with the Rider Select (1-5) adjustable steering column the Sentinel guards
will hit the windshield in the #5 position.
On machines with a flat top steering post we suggest using a 45503 2” non-pivot riser block to
improve rider comfort and make clearance for the Sentinel handguards. No changes to cables
are need with this riser.
If your sled has the full rubber handle bar cover (photo 1) you
will need to:
Photo 1
1. Cut slots in your rubber cover for the handguard mounting
brackets. See instructions below (photo 2&3).
2. Remove cover and install a handle bar cover and install
PowerMadd’s riser bag p/n 73603 (2” riser required) see
photo 4 or PowerMadd fat bar pad p/n 44261 see photo 5.
Photo 2
Use these instructions along with the instructions provided with
the 34450 mount kit.
Remove full rubber handle bar cover if you have one at this time.
Photo 4
Photo 5
Photo 3
Right side:
Mount the handguard mounting bracket just to the left of the
throttle block as shown in the photo 6.
Mount bracket into mounting tabs on the handguard as shown in
the photo. Adjust guard and throttle to your personal preference.
If you are using the OEM rubber handlebar cover cut a slot in the
cover with an exacto-knife as shown in the photo.
Left side:
Mount the handguard mounting bracket just to the right of the
control pod with the bracket going over the top the lever as shown
in the photo 7. Mount bracket into mounting tabs on the
handguard as shown in the photo 7. Adjust guard and brake lever
to your personal preference.
Photo 6
Photo 7