PowerMadd Sentinel handguard mounting on Polaris Edge chassis

PowerMadd Sentinel handguard mounting on Polaris Edge chassis
Using 34450 Sentinel Snowmobile Mount Kit
Use these instructions along with the instructions provided with the 34450 mount kit.
We suggest using a 45503 2” non-pivot riser block to
improve rider comfort and make clearance for the Sentinel
handguards
Photo 1
If your sled has the full rubber handle bar cover (photo 1) you
will need to:
1. Cut slots in your rubber cover for the handguard mounting
brackets. See instructions below (photo 2&3).
Photo 2
2. Remove cover and install a handle bar cover and install
PowerMadd’s riser bag p/n 73603 (2” riser required) see
photo 4 or PowerMadd fat bar pad p/n 44261 see photo 5.
If your sled has the full rubber handle bar cover (photo 1) you will
need to remove the cover to install the handguards.
Photo 4
Photo 3
Photo 5
Right side:
Mount the handguard bracket just to the left of the throttle block
as shown in the photo. Mount bracket into mounting tabs on the
handguard as shown in the photo. Adjust guard and throttle to
your personal preference. If you are using the OEM rubber
handlebar cover cut a slot in the cover with an exacto-knife as
shown in the photos 2 & 3.
Left side:
Mount the handguard mounting bracket just to the right of the
control pod with the bracket going over the top as shown in the
photo 7. Mount bracket into mounting tabs on the handguard as
shown in the photo. Adjust guard and brake lever to your personal
preference.
Photo 6
Photo 7